Danita APA100 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssystem Danita APA100 herunter. Danita APA100 8 Seiten. Superguard alarm system

Receiver:

Insert a battery of the type LR6 or AA in the receiver.

2 green light means the battery level is low.

Upper position: On + Beep and light.

Middle position: On + Vibration and light.

Lower position: Off

Press the knob: Show last alarm. Next press reset the alarm.

When On show 3 red ﬂash. If nothing more happens it is in standard mode.

If red and green light is added, the receiver is in Out Of Range mode.

When an alarm is received, the code of the transmitter (trigging) is shown

for eight seconds. After these eight seconds, the receiver gives a short indi-

cation every eight second, until the reset knob has been activated.

Press two times and the receiver is reset.

In case a new receiver is bought, it has to be coded to the transmitter.

1. Press down the reset knob, when the receiver is pushed On. Three

ﬂashes and sound or vibration will occur. Then the receiver will ﬂash

quickly for ﬁve seconds.

2. When the receiver ﬂashes quickly, release the reset knob.

3. Press down three times on the reset knob within the ﬁve seconds

during which the receiver ﬂashes quickly.

4. Red light lights up permanently.

5. Within ten seconds, a call from the transmitter (trigging) shall be made.

6. If successful, the alarm from the transmitter is shown. If the coding

fails, green light is shown for one second.

Press down the reset knob and turn on the receiver at the same time, until

three red lights have been shown. Now red light ﬂashes quickly. Press three

times on reset knob. The red light continues, wait for ten seconds till the

green light has been shown. Now red light ﬂashes quickly again. Press

three times at the reset knob and the receiver shows the mode. If standard

mode: No light. If "Out Of Range": Green and red light is shown.

(Same procedure, but each second time it shifts mode)