Conrad-Johnson LP70S Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Conrad-Johnson LP70S herunter. Conrad-Johnson LP70S 12 Seiten. Vacuum-tube amplifier

Seite drucken

pecifications

Power:

ohms from 30Hz to 15KHz at no more than 1.5% total harmonic

distortion or intermodulation distortion (can be re-connected in-

ternally for 8 or 16 ohm loads).

Sensitivity: .5 V rms to rated power

Small Signal Distortion: less than .2% at mid-band

Frequency Response: 20Hz to 20 kHz +0/-.25 dB

Hum and Noise: 102 dB below rated power output

Phase: phase correct

Input Impedance: 100 kOhms

Mechanical

Dimensions: 16.125"D x 19"W x 6.375"H

Net Weight: 54 lb net

Fuses

The LP70S power transformer is protected by a fuse on the ac

power line (F5, located in a compartment in the ac line-cord recep-

tacle mounted on the back of the amplifier), and by four separate

internal fuses on t h e secondary circuits of the transformer (F1 –

F4) located on the bottom of the pc board. A failure of any of these

fuses is a symptom of a more serious problem, and a competent

service technician should be consulted. In no event should fuses

be replaced with a value or type different than that originally sup-

plied. The correct fuse values and types are:

70 watts per channel RMS both channels driven into 4

F5:

5x20mm 5 amp T-type if configured for 100 or 120V:

5x20mm 3 amp T-type if configured for 220 or 240V.

F4: 3AG type 4 amp, slow blow

F1, F2, and F3: ¼ amp, slow blow

LP70S Owner's Manual