DANLERS TWSW Hinweise zur Installation

Blättern Sie online oder laden Sie pdf Hinweise zur Installation für Schalter DANLERS TWSW herunter. DANLERS TWSW 2 Seiten. Twilight switch

Seite drucken

Variants

As DANLERS design and manufacture in the UK, variants can be supplied,

coded by the following suffixes, applied in this order:

• 12V or 24V

12V or 24V ac or dc operation

• VF

Volt Free contacts

• NC

Normally Closed contacts

• G or LG

Gold or Logic Gold contacts

The details of these variants are covered by an enclosed variant

addendum if applicable.

Trouble shooting

The lamp switches off about 5 seconds after it switches on.

• To much artificial light is entering the dusk switch.

The lamp switches on too early in the evening.

• Move the Lux adjuster further towards clockwise.

The lamp switches on too late in the evening.

• Move the lux adjuster further anticlockwise.

The TWSW stops working.

• Ensure the unit is mounted correctly so that no water can enter.

Precautions and Warranty

This product conforms to BS EN 60669-2-1.

Please ensure the most recent edition of the appropriate local wiring regulations are observed

and suitable protection is provided e.g. 6 amps over current, 1kV over voltage. Please ensure

that this device is disconnected from the supply if an insulation test is made.

This product is covered by a warranty which extends to 5 years from the date of manufacture.

Products available from DANLERS

• PIR occupancy switches • Daylight linked dimmers • Manual high frequency dimmers

• Photocells • Radio remote controls • Time lag switches • Outdoor security switches

• Dimmers • Heating, ventilation and air-conditioning controls • Bespoke / O.E.M. products

Please call for more information or a free catalogue.

DANLERS Limited, Vincients Road, CHIPPENHAM, Wiltshire, SN14 6NQ, UK.

Telephone: +44 (0)1249 443377 Fax: +44 (0)1249 443388

E-mail: [email protected]

Web: www.danlers.co.uk

Company Registered Number 2570169 VAT Registration Number 543 5491 38

06/04/11

Twilight Switch

TWSW

DANLERS Twilight Switch can be surface mounted onto an external

wall. The TWSW will switch a lamp load on during the hours of

darkness. The light level at which the lamp will switch on and off is

set by a lux adjuster.

The TWSW should only be connected to a 230V 50Hz ac supply.

It can switch the following type of loads:

• 6 amps (1500W)

• 4 amps (1000W)

• 2 amps (500W)

• 1 amp (250W)

INS971 TWSW

Incandescent or mains halogen lamps

(recommended with integral safety fuse)

Electronic or wire wound transformers.

Fluorescent lamps (high frequency or soft start)

Compact fluorescent or LED lamps (about 50 lamps)

Most metal halide lamps and fans.

Installation notes