aevit SMART-SHIFT Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Kraftfahrzeuge aevit SMART-SHIFT herunter. aevit SMART-SHIFT 16 Seiten.

2.2 MOUNTING THE SMART-SHIFT ACTUATOR BRACKET

Each vehicle is different, depending on the vehicle type, amount of body lift and length of the shift cable.

Start by pulling the shift cable into the engine bay and seeing where it will reach without contacting anything

hot or needing sharp bends.

More often than not, the best location to mount the actuator bracket is above the engine on the wiper tray or

lower cowl panel. Both ends of the bracket must be attached to something rigid, not something connected

to the motor where there is flex. Some vehicles have threaded studs for hoses or wire looms that the actuator

bracket can be hung from. EMC includes small steel brackets that can be bent or drilled to hold either end of

the actuator bracket. Rivnuts or thru-bolts are also options.

Below are pictures of installed actuator brackets showing possible attachment methods.

Once securely attached, loop the shift cable around and over parts as needed to avoid kinks and hot surfaces.

P-clamp it periodically to hold it in place. Route the actuator harness back into the cabin through an open

grommet or the through the hole used for the shift cable. Seal around the harness to prevent water and fumes

from entering back into the cabin.

SMART-SHIFT INSTALLATION