Conservator VDF200 Series Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Geschirrspüler Conservator VDF200 Series herunter. Conservator VDF200 Series 16 Seiten.

Troubleshooting Tips... Before you call for service
Problem
Suds in the tub
Detergent cup lid
won't latch
Detergent left in
dispenser cups
Black or gray marks
on dishes
Dishes don't dry
Control panel
responded to inputs
but dishwasher never
filled with water
Stained tub interior
49-4000062 Rev 0
Possible Cause
Wrong detergent
Rinse agent was spilled
Dial is not in the OFF
position
Dishes or utensils are
blocking the detergent cup
Aluminum utensils have
rubbed against dishes
Low inlet water temperature
Rinse agent dispenser is
empty
Door latch may not be
properly seated
Water valve may be turned
rned
off
Some tomato-based foods
ed foods
food
can cause reddish stains
ish stains
ish stains
Tea or coffee stains
e stains
e stains
An overall yellow or brown
film can be caused by iron
deposits in water
White film on inside
surface— hard water
minerals
Use only automatic dishwasher detergents to avoid sudsing.
Finish
Quantum
®
®
has been approved for use in all GE Appliances
dishwashers.
To remove suds from the tub, open the dishwasher and
let suds dissipate. Add 1 gallon of cold water to the tub.
On Models with a dial: Close and latch the dishwasher.
Pump out water by slowly turning the dial until a drain
period is reached. Repeat if necessary.
Always wipe up rinse agent spills immediately.
Turn the timer dial to OFF.
Reposition the dishes. See the Loading section.
Remove marks with a mild, abrasive cleaner.
Make sure inlet water temperature is at least 120°F.
Select HEATED DRY.
ED DR
D
Use HOT START and HEATED DRY ON options.
START
RT
and
Select a higher cycle, such as HEAVY WASH.
a higher cycle, su
higher cyc
Check the rinse agent dispenser and fill as required.
eck the rinse agen
eck the rinse agen
Call for service.
Call for service
all for service
d
Make sure
Make sure
Make sure water valve (usually located under the sink) is
turned
turned
turned on.
Use of the RINSE ONLY cycle after adding the dish to
U
Use
the load can decrease the level of staining.
th
th
Remove the stain by hand, using a solution of 1/2 cup
bleach and 3 cups warm water.
Before cleaning interior, wait at
CAUTION
least 20 minutes after a cycle for
the heating elements to cool down. Failure to do so
can result in burns.
PRECAUCIÓN
20 minutos luego de un ciclo, hasta que los
elementos de calentamiento se enfríen. Si esto no
se cumple, se podrán sufrir quemaduras.
A special filter in the water supply line is the only way to
correct this problem. Contact a water softener company.
GE Appliances recommends
to help prevent hard water mineral deposits from forming.
Run dishwasher with citric acid to remove mineral
deposits. Citric acid (Part number: WD35X151) can be
ordered through GE Appliances Parts. See Consumer
Support section for ordering information. Alternatively,
purchase
Finish
Dishwasher Cleaner
®
directions on the label.
What To Do
Automatic Dishwashing Detergent
until a drain
mediately
ately.
he
e
Loading
Loading
sectio
sectio
mild, abrasive cle
mild, abrasive cle
emperature
emperatur
Antes de limpiar la parte
interna, espere por lo menos
Finish
Jet-Dry
®
®
and follow the
r and
r and
the tu
the tub
.
shwasher
hwasher.
.
drain
Rinse Aid
13