Dansons Group CC1 Betriebshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Pellet-Ofen Dansons Group CC1 herunter. Dansons Group CC1 13 Seiten. Dansons group inc. pellet stove can/csa b365 operations guide

Seite drucken

WARNING: Disconnect the electrical cord prior to opening the sides of your stove or opening the

exhaust system for any inspection, cleaning, maintenance or service work. NEVER perform any

inspection, cleaning, maintenance or service on a HOT STOVE or when the cord is plugged in.

(cont'd)

HOPPER CLEANING -

that are sticking to the hopper surface and clean as needed.

GLASS REPLACEMENT -

size and thickness may be used. Contact your Authorized Dealer to obtain this glass.

DO NOT OPERATE YOUR STOVE WITH BROKEN GLASS!

DOOR GASKET -

Inspect the main door gasket periodically. The main door may be removed to

have frayed, broken or compacted gaskets replaced by your Authorized Dealer.

FAN MOTORS -

Clean the intake on the CONVECTION FAN (circulation) as well as the holes on the

motors of both COMBUSTION and CONVECTION FANS annually. Disassemble the COMBUSTION FAN

and clean out the internal fan blades as part of your fall season startup.

FRESH AIR INTAKE -

A plugged screen will restrict or shut off combustion air and cause a fire to burn poorly or die out.

GOLD/BRASS TRIM CLEANING -

ANY ABRASIVE CLEANSERS AS YOU WILL REMOVE OR SCRATCH THE PLATING!

INSPECT AND CLEAN VENTING -

flow of flue gases. Check the clean out tees and elbows in the system periodically to determine the

required schedule of cleaning. To remove dust from the vent pipe, lightly tap on the pipe to dislodge

loose ash. Open the bottom of the tee to dump the ash, then use an ash vacuum to remove as

much ash as possible from the pipe. 3" and 4" chimney brushes are available for cleaning. If the

exhaust system has a screen on it, frequently clean the screen. A plugged screen will shut down

the stove or cause the fire to burn poorly or die out.

PAINTED SURFACES -

appear or you wish to renew your paint, contact your Dealer to obtain a can of 'satin black' (Stove

Brite brand) TIP: Use a hair dryer to warm the surface prior to touching up the paint; this helps to

reduce paint runs.

NOTE: Do not use any other brand than Stove Brite as they may not be compatible.

SPRING SHUTDOWN -

- remove pellets from hopper and auger

- vacuum out the hopper

- thoroughly clean the burn grate, burn

box, ash traps and ash bin

A yearly servicing and cleaning by your Authorized Dealer is recommended. Please

consult with your Dealer for availability of this service, time involved and possible fees.

Check the hopper periodically to determine if there is any sawdust or pellets

In the event you need glass replacement, only Neo-Ceram of the correct

Inspect periodically to be sure that it is not clogged with any foreign materials.

Use a damp cloth to clean your door and trim. DO NOT USE

Fly ash will collect in the exhaust venting system and restrict the

Painted surfaces may be wiped down with a damp cloth. If scratches

After the last burn in the spring, complete the following tasks:

ROUTINE CLEANING

- consider spraying the inside of the cleaned

hopper with an aerosol silicone spray if

your stove is in a high humidity area

- thoroughly clean exhaust system

REQUIRED

(see above)