Consonance CD120 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für CD-Spieler Consonance CD120 herunter. Consonance CD120 6 Seiten.

AC Power connection 240V / 230V / 220V / 115V / 100V AC dependent on country.

Digital output Phono/RCA

Balanced signal outputs XLR right/left

Unbalanced outputs Phono/RCA right/left

We recommend to connect signal cables to the CD-player when the CD-player and all the

other units of the audio system is switched off.

The CD-player has two types of analog audio outputs: unbalanced audio signal with RCA

plugs (phono plugs) and true balanced audio signal with XLR plugs (pin 2 is positive phase,

pin 3 is negative phase and pin 1 is chassis earth).

We will recommend using the balanced XLR outputs from the CD-player, as these will have

the absolute highest level of sound quality.

The CD-player has got one RCA standard SPDIF digital audio output. Digital signal level is

0.5Vpp when terminated in 75 ohm load. This is the standard load impedance of external

DAC's and other recording equipment.

CONSONANCE REMOTE CONTROL

The Consonance CD120 can be controlled by remote control. Like other Hi-End products, the

number of buttons on the remote is kept to a minimum.

The remote control uses two 1.5-volt LR03 AAA batteries.

USE & PLACEMENT

The Consonance CD120 should be placed on a flat, hard surface for proper isolation against

vibrations. The CD-player performs best after being switched on for about 30 minutes for

heating upage A certain space is required for air circulation above and below the CD-player.

The CD-player must never be placed on a carpet or similar surface that obstructs air

circulation through the component. Nor must it be covered while in use or placed on a narrow

shelf or in another confined space.