Consort SLPBWP Handbuch für Installation und Steuerung - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Steuerung für Temperaturregler Consort SLPBWP herunter. Consort SLPBWP 4 Seiten. Wireless controller

Seite drucken

9. Installation

The controller can be powered by either mains

240VAC 50Hz or 12VDC. The power consumption is less

than 1W. Do not connect mains voltage to 12V

terminals, this will damage the controller. The

maximum size wire that can be used is 1mm

be twin and earth or standard flex . Do not overtighten

the connector screws. Take care not to damage the

components when connecting the cables.

The gland outlet can be positioned at the top or

bottom of the controller this will depend on the

installation.

The controller comes with 4 wall plugs suitable for a

5mm hole and 4 screws. See the diagram on the right

for installation assembly.

11. Connection to 12V DC

When powering the controller with 12Vdc, the installation must comply with the Separated Extra Low Voltage (SELV)

requirements. When powered by 12VDC, please ensure that the power supply is suitable for 12V 0.1A. For 12VDC

power connect positive wire to terminal marked +12V and negative to terminal marked –12V.

12. Self Diagnostic

The controller is equipped with a self diagnostic software that will check functionality of all main components. If

there is a fault with any part of the controller or the controller is operating outside of the temperature limits, the light

indicator will flash red . If this happens, controller will not function in order to protect itself and the heaters.

13. Pairing with heaters

In order to pair your appliance with the controller you must do the following:

 Ensure the controller is in the OFF position (the light indicator is off or red).

 Turn power to the appliance ON.

 Within 20 seconds, press and hold the ON button on the controller until the light indicator begins to flash yellow.

 After the pairing is finished, the light indictor will change to green.

 If the pairing was successful, the appliance should emit heat. It can take up to 4 seconds.

 After 4 seconds, the appliance will be switched off.

 The appliance is now ready to be used.

. This can

Mains Connection

230/240V AC 50Hz

12V DC