Cast LAVA Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Holzofen Cast LAVA herunter. Cast LAVA 20 Seiten.

and avoid abrupt heating with excessive loads.

To light the fire, it is suggested using small wood pieces together with paper or other traded lighting means.

It is FORBIDDEN to use any liquid substance as for ex. alcohol, gasoline, oil and similar.

Operation with wood:

Open the primary and secondary air control and lit the fire.

After establishing stable operation regime (10 to 15 min), close the primary regulator and adjust the desired

operation regime.

The openings for air (primary and secondary) must be opened together just until the stable operation

regime of the furnace is achieved. Never overload the stove.

Too much fuel and too much air for the combustion may cause overheating and then damage the stove.

16. REGULAR EXPLOITATION

IMPORTANT: due to the fact the door of the hearth has a remarkable size, we suggest you to open the

door very slowly, to avoid the exit of smokes and flames.

For safety reasons the door of the hearth can be opened during the stove operation only for the loading of

the fuel. The hearth door must always remain closed during operation.

Before opening the hearth door, open the primary air regulator, open the door slowly, load the fuel, close

the door and after about 5 or 10 minutes close the primary air control.

Heat emission is adjusted via regulators located on the front side.

They must be opened according to the calorific need. The best combustion is reached when most of the air

for the combustion passes through the regulator of secondary air.

Never overload the stove (compare the technical table - max. quantity of loadable fuel).

The warranty does not cover the damages due to overheating of the equipment.

You should always use the stove with the door closed in order to avoid damages due to overheating.

The adjustment of the regulators is as follows:

Fuel

Wood

Mass of fuel hourly

Besides the adjustment of air for the combustion, the intensity of combustion and then the calorific value of

your stove depend from the chimney. A good flue of requires a more reduced adjustment of

air for the combustion.

To verify the good combustion of the stove, check if the smoke coming out from the chimney and if the

smoke is gray or black, it means that the combustion is not complete (a greater quantity of

secondary air is necessary).

Secondary air (A1)

Open

3,2-3,3 kg/h

Primary air (B1)

Closed

3,2 -3,3kg/h