Constructor 5411074140878 Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Bohrer Constructor 5411074140878 herunter. Constructor 5411074140878 13 Seiten. Electronic hammer drill
Seite druckenGB -
WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the
enclosed safety instructions as well as
the additional safety instructions.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION (FIG. 1)
Your electronic hammer drill has been
designed for drilling in wood, metal, plastic,
stone and concrete and it also has been
designed for screw driving applications.
1 Lock button
2 On/off-switch
3 Forward/reverse switch
4 Chuck
5 Switch hammer drill function
6 Side handle
7 Depth stop
8 Gear selector
INSERTING AND REMOVING A DRILL OR
SCREW BIT (FIG. 1)
O pen the chuck (4).
I nsert the drill or the screw bit in the chuck.
T ighten the chuck by hand.
I n order to remove a drill or screw bit,proceed
in reverse order.
Before inserting or removing a drill or screw bit
always remove the plug from the outlet.
MOUNTING THE SIDE GRIP (FIG. 1)
L oosen the knob on the side grip.
ELECTRONIC HAMMER DRILL
S lide the side grip (6) over the chuck on the
machine.
T urn the side grip in the required position and
tighten the knob firmly.
MOUNTING THE DEPTH STOP (FIG. 1)
The depth stop is used to limit the maximum
drilling depth.
L oosen the knob on the side grip.
I nsert the depth stop (7) in its intended hole in
the side grip.
S et the depth stop to the required drilling
depth.
T ighten knob firmly.
SELECTING THE OPERATING MODE
Select the required operating mode before
use (drilling or hammer drilling).
F or drilling in wood, metal, plastics and
soft stone and for driving screws, turn the
drill symbol on the switch (8) to the arrow.
F or drilling in masonry, turn the hammer
and drill symbol on the switch (8) to the
arrow.
Always wait until the motor has
come to a complete standstill
before changing the operating
CHANGING THE DIRECTION OF ROTATION
(FIG. 2)
P ress the forward/reverse switch (3) to the left
to drill or to fasten screws.
P ress the forward/reverse switch (3) to the
right to loosen screws.
S et the forward/reverse switch (3) to the
middle position to lock the machine.
Always wait until the motor has
come to a complete standstill
before changing the direction of
mode.
rotation.
7