AudioSource EQ 200 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Stereo-Entzerrer AudioSource EQ 200 herunter. AudioSource EQ 200 12 Seiten. Ten-band stereo graphic equalizer with spectrum analyzer display
Auch für AudioSource EQ 200: Benutzerhandbuch (4 seiten), Benutzerhandbuch (7 seiten), Benutzerhandbuch (5 seiten)

Seite drucken

Using The Controls

Level Controls: Both left and right channels have a control marked "Level". This con-

trols the level, or volume of each channel. Usually, these controls can be set to their

Left Level, or

maximum position, but these levels can be reduced if an overly strong input signal

Right Level

causes distortion. Usually, similar adjustments should be made for both channels.

EQ Sliders : Each of these sliders will give 12Db. of "Boost" and 12 dB. of "Cut".

There are ten sliders per channel - Ten for the Left channel, and Ten for the Bight

channel. Looking at the front panel, the sliders that control the lowest frequencies are on

the left, with the higher frequencies farther right. Usually, identical adjustments should

be made for both channels. These sliders are One Octave apart from one another. This

corresponds with the entire range of human hearing. The last page of this owner's manual

contains a chart, showing which sliders to adjust to affect the sound of various instru-

ments. For instance, the lowest note of a Bass Guitar is at 42 Hz.. By adjusting the

sliders at 30 Hz. and 60 Hz., you can raise or lower the volume of the bass guitar, bass

drum, and any other musical instruments that occupy this frequency range. In another

instance, the sound of the female vocalist occupies a frequency range from roughly 200

Hz. to 1500 Hz.. By adjusting the sliders within this range, you can change the tonal

character of the female voice, and any other musical instruments that occupy this fre-

quency range.

Spectrum Analyzer Splay:

This provides a visual display of the relative signal lev-

els in each of the EQ Sliders. The Spectrum Analyzer display is divided into ten col-

umns of LED's which correspond to the ten EQ Sliders. You can use this display to

assist you in setting your equalizer sliders, as well as to obtain information about the

frequency content of the music as you play it through the EQ 200.