3xLogic infinias eIDC32 Schnellstart-Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Gateway 3xLogic infinias eIDC32 herunter. 3xLogic infinias eIDC32 17 Seiten.

Seite drucken
3xLogic infinias eIDC32 Schnellstart-Handbuch
ì

PoE SWITCH

1. Using PoE, run a standard network cable (Cat 5 or Cat 6) directly
from the Ethernet switch to the eIDC.
2. Put an Uninterruptable Power Supply (UPS) at the switch to
provide redundant power.
3. Go to
installation.
î=

NON-PoE WITH MIDSPAN PoE INJECTOR

1. Using non-PoE, run a standard network cable (Cat 5 or Cat 6)
directly from the Ethernet switch to the Midspan PoE Injector.
2. Put an Uninterruptable Power Supply (UPS) to both the Midspan
PoE Injector and the switch to provide redundant power.
3. Run another standard network cable (Cat 5 or Cat 6) from the
Midspan PoE Injector to the eIDC Ethernet connector.
4. Go to
installation.
ï=

NON-PoE SWITCH

1. Using non-PoE, run a standard network cable (Cat 5 or Cat 6)
directly from the Ethernet switch to the eIDC.
2. Wire a redundant 24 VDC power supply to the eIDC and then apply
power.
3. Go to
installation.
ñ=

NON-PoE WITH POWER INJECTOR

1. Using non-PoE when only a small number of ports will require PoE,
run a standard network cable (Cat 5 or Cat 6) directly from the
Ethernet switch to the Power Injector.
2. Wire a redundant 24 VDC power supply to the Power Injector and
then apply power.
NOTE: With PoE, the external power supply connected to the
Power Injector may not be required. If both a PoE-enabled switch
QSG-002 / 01-03-2017
Determine the eIDC IP Address
Determine the eIDC IP Address
Determine the eIDC IP Address
on page 8 and complete the
on page 8 and complete the
on page 8 and complete the
7