DAPAudio D4203 Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Verstärken DAPAudio D4203 herunter. DAPAudio D4203 17 Seiten. Dap audio falcon stage amp series

Seite drucken

Backpanel

10. Fuse

Replace the fuse only by a fuse of the same type (F8A, 6x32mm).

11. Output A Speakon Connector

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo mode, to channel A connector for Bridged mono mode.

12. Channel B In/Through Connectors

These connectors accept input signals on XLR input plugs, See the section on connecting cables on

page 10/11 for information on polarity, Connectors for each channel are in parallel, The unused

connectors may be used for linking to other amplifiers.

13. Channel A In/Through Connectors

These connectors accept input signals on XLR input plugs, See the section on connecting cables on

page 10/11 for information on polarity, Connectors for each channel are in parallel, The unused

connectors may be used for linking to other amplifiers.

14.

AC Inlet

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the Power switch (9) to

operate the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

15. Air cooling window

This part is the air cooling window. Don't obstruct it.

16. Output B Speakon Connector

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo mode, to channel A connector for Bridged mono mode.

17. Stereo/ Bridge Switch

The two-position, Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo or Bridged Mono Mode.

Fig. 3