DAPAudio EM-7.2 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Musik Mixer DAPAudio EM-7.2 herunter. DAPAudio EM-7.2 16 Seiten. Professional
Auch für DAPAudio EM-7.2: Benutzerhandbuch (12 seiten)

Seite drucken

Installation

Remove all packing materials from the EM-7.2. Check that all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Functions

2. Overload Indicator

The overload indicator shows peak levels in a channel's incoming signal level. If the red overload LED

frequently blinks or constantly lights, the corresponding channel is likely to enter clipping and you have to

reduce the input's amplification using the level control. The overload LED lights at a level of 8 dB below

clipping. Make sure that the overload LED lights only briefly during dynamic peaks.

3 / 4 / 5. Equalizer SECTION (HI / MID / LOW)

The mixer's Equalizer section allows shaping of the incoming audio signal. All mono

Input channels are fitted with 3-band EQ. The Hi (5) and Low (3) shelving controls have their frequencies

fixed at 12KHz and 80Hz respectively. The Mid (4) range control has a peaking response frequency at

2.5KHz. All 3 bands have up to 12dB cut and boost, with a centre detent for. Turning the Equalizer to the

right amplifies the frequency range, turning to the left attenuates the signal. Minor changes to the

Equalizer control usually produce the best results. Try to avoid excessive enhancement of the MID band.

6. Talkover On Switch

Use this switch to activate the talkover function.

7.Power LED

The red power LED lights when the Sessionmix is turned on. If after switching the device on, the LED does

not light, make sure that the AC adapter is connected properly. If the LED still doesn't light up after

everything is connected right, please contact your DAP audio.

8. MIC Level (Mic 1/2)

Controls the volume of the Microphone channel.

9. Talkover Amount Control

Use this control to set the amount of signal reduction for the line channels 1-5 when spoken in the

microphone.

10. Talkover Time Control

This control allows you to set the time for returning to the normal volume level of the line channels 1-5 if

you stop speaking in the microphone.

11. Mute Switch

Use this switch to mute the according Microphone channel.

1. MIC

Electronically balanced XLR-type input for connecting low

impedance microphones. The input has extremely low noise

and low hum. When connecting a microphone make sure

that the pin assignment is correct. Always make sure to read

the manual of the microphone you want to connect. The

XLR- input is not suitable for connecting an additional mixing

console, FX- unit, etc. You have to use the Line- inputs, when

connecting this kind of equipment.

Note: When connecting signal sources, please make sure

Fig. 3

that the corresponding channel faders and the master

faders are at their minimum settings. Otherwise unpleasant

plug-in noise can occure.