DAPAudio IMIX-5.3 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musik Mixer DAPAudio IMIX-5.3 herunter. DAPAudio IMIX-5.3 16 Seiten.

12. Zone assign buttons

Use these 3 buttons to assign the corresponding channel to one or more zones.

13. Channel fader

A logarithmic 50mm fader, which controls the volume of the corresponding channel. The overall volume

is set with the master control.

18. Power LED

Indicates that the IMIX-5.3 is switched on.

19. Power on/off switch

Do not supply power before the whole system is set up and connected properly.

20. Aux RCA in connectors

Unbalanced stereo RCA aux input for connecting a line/phones level device. Use the phone/line (21)

button to set up this input for connecting either headphone or line level output devices.

21. Phone/line button

Use this button to configure both aux (17,20) inputs for either line level or headphone level.

22. Output signal VU-meter (zone A/B/C)

This meter is a multi-step LED. The accurate level indication allows you to monitor the output signal level

at anytime, and match with other devices.

23. Level control (zone A/B/C)

Allows you to adjust the output signal to the zone A/B/C (31-36, 45) outputs.

24. Balance control (zone A/B/C)

By using the bal(ance) control you can adjust the balance between the left and the right channel.

25. PFL button

The PFL button (pre fade listening) is designed to route the corresponding zone to the headphone

section. It is possible to assign more than one zone simultaneous to the PFL bus.

26. Zone assign buttons

Use these 3 buttons to assign the aux channel to one or more zones.

27. Headphones level control

This control allows you to adjust the headphones' volume.

14/15/16. Equalizer section (zone A/B/C)

The zone equalizer section allows shaping of the outgoing audio

signal. All input channels are fitted with 3-band EQ. The high (15) and

low (16) shelving controls have their frequencies fixed at 10 KHz and

100 Hz respectively. The mid (14) range control has a peaking

response frequency at 1 KHz. All 3 bands have up to 12dB cut and

boost, with a centre detent for. Turning the equalizer control to the

right amplifies the frequency range; turning to the left attenuates the

signal. Minor changes to an equalizer control usually produce the best

results. Try to avoid excessive enhancement of the mid band.

17. Aux mini jack in connector

Unbalanced stereo mini jack aux input for connecting a line/phones

level device. Use the phone/Line (21) button to set up this input for

connecting either headphone or line level output devices.