Duratool D03175 Schnellstart-Handbuch
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Elektrowerkzeug Duratool D03175 herunter. Duratool D03175 2 Seiten.
Seite drucken
IMPORTANT SAFETY INFORMATION
•
When using electrical appliances basic safety precautions should always be
followed.
•
Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
•
Do not operate the appliance with a damaged plug or cord, after a malfunction or
after being dropped or damaged in any way.
•
If the supply cord is damaged, it must be replaced by a qualified engineer in order
to avoid injury or a hazard.
•
Ensure there is sufficient space and ventilation around the appliance to allow the
escape of heat and/or fumes.
•
Do not expose to rain or moisture.
•
Never place the product or part of it in water, or operate if your hands are wet.
•
Soldering work must be conducted on a stable, non-combustible surface.
•
Do not touch any metallic parts near the soldering tip/nozzle.
•
The iron must not be left unattended while it is connected to the supply mains.
•
Turn the soldering iron off and unplug it when it is not in use.
APPLICATION & OPERATION
•
40W model (D03174): Radio controls, hobbies and crafts, small electrical
parts.
•
60W model (D03175): Household electrical appliances, capacitors etc.
•
File off any dirt, rust or paint on the part you wish to solder.
•
Heat the part with the soldering iron.
•
Apply rosin-based solder to the part and melt it with the soldering iron.
Note: When using non-rosin-based solder, ensure you apply a soldering
paste to the part before applying the solder.
•
Wait for the solder to cool and harden before moving the soldered part.
Note: The first time you use the soldering iron, it may smoke
slightly as the heating element dries out. This is normal and
should only last for approximately 10 minutes.
Soldering Iron
Model: D03174 & D03175