Duratool DT000472 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Elektrowerkzeug Duratool DT000472 herunter. Duratool DT000472 4 Seiten.

Apply rosin-based solder to the part and melt it with the soldering iron.

Note: When using non-rosin-based solder, ensure you apply a soldering paste to the part before applying the solder.

Wait for the solder to cool and harden before moving the soldered part.

Note: Lightly dampen the sponge with water before use. Before soldering, clean the tip on the sponge and then tin the tip with

fresh solder. Do not use the sponge dry.

Between use (or during breaks), always put the soldering iron in the holder.

When the soldering work is done, switch off the power first, clean the tip and tin with fresh solder to protect it from oxidation.

Never file down the tips or attempt to clean using abrasives

Tip Replacement

Replacing the tip should only be done when the iron is switched off and at room temperature.

The tip can be changed or replaced by unscrewing the knurled nut barrel.

It is imperative that the iron is switched off, unplugged and allowed to cool before and after tip replacement.

Caution: Damage could occur if the iron is left on without the tip inserted.

After removing the tip, blow out any remaining oxide dust that may have formed in the tip retaining area of the barrel.

Warning: Care should be taken to avoid getting dust in your eyes.

Replace the tip and tighten the knurled nut barrel assembly with your hands.

Pliers should only be used to tighten the nut if loosening occurs when the iron is hot.

Do not over tighten the nut as the element could be damaged.

Cleaning

Cleaning should only be done when the iron is switched off and at room temperature.

The iron may be cleaned with a damp cloth and a small amount of liquid detergent if necessary.

Newark.com/exclusive-brands

Farnell.com/exclusive-brands

Element14.com/exclusive-brands

Page <3>

03/04/19

V1.0