DAPAudio D2180 Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für DJ-Ausrüstung DAPAudio D2180 herunter. DAPAudio D2180 15 Seiten.

Backside

19) Record RCA Unbalanced Out

20) Channel 4 L1 RCA Input

21) Channel 3 Level Selector

22) Channel 2 Level Selector

23) Channel 1 L1 RCA Input

24) GND

25)

AC Inlet with integrated fuse holder

26) Master RCA Unbalanced Out

Remove all packing materials from the DS-CM-4. Check that all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

1. MIC

Electronically balanced XLR-type input for connecting low impedance

microphone. The input has exremely low noise and hum processing. When

connecting a microphone make sure that the pin assignment

is correct. Always make sure to read the manual of the microphone you want to

connect. The XLR- input is not suitable for connecting an additional mixing

console, FX- unit, etc. You have to use the LINE-inputs, when connecting this kind

of equipment.

Note: When connecting signal sources, please make sure that the corresponding

channel faders and the master faders are at minimum settings. Otherwise

unpleasant plug-in noise can occur.

2. MIC Channel ON Switch

Use this switch to enable the Mic channel.

3. DJ MIC Level

Controls the volume of the Microphone channel.

27) Channel 4 L2 RCA Input

28) Channel 3 L2 RCA Input

29) Channel 3 PH1L1 RCA Input

30) Channel 2 L2 RCA Input

31) Channel 2 PH1/L1 RCA Input

32) Channel 1 L2 RCA Input

33) Mic 2 Jack Unbalanced Input

Fig. 2