Duratuf Gurdian Sheds GG101 Montageanleitung Handbuch - Seite 11
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Lagerung im Freien Duratuf Gurdian Sheds GG101 herunter. Duratuf Gurdian Sheds GG101 16 Seiten.
Seite drucken
ASSEMBLE FRONT PANEL
SELECT:
3 x 1.890 Wall Sheets
1 x 1.890 1 Pan Wall Sheet
1 x 3.190 Top Plate (Red)
1 x 3.190 Bottom Plate (Green)
2 x 1.890 Door Jamb Flashings
44 x 30mm Galv Clouts
30 x Rivets
STEP 1:
• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat
surface as shown
NOTE:
The Doorway is standard at 705mm from left-hand end.
To shift the doorway to the right-hand side of the front
wall, simply measure 705mm from the right-hand end.
STEP 2:
• Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with
the top of the Top Plate at the correct measurement as shown
in plan view. Pre drill holes using a 3.5mm drill bit
• Check the distance between the top and bottom plates then use
a further 2 x 30mm clouts to nail the Door Jamb Flashings to
the bottom Plate. Pre drill holes.
STEP 3:
• Place 3 x Wall Sheets & 1 x 1pan sheet on timber, ensuring
wall sheets fit underneath door jamb flashings.
• Ensure that the top of the sheets are flush with the top of the
Top Plate and that the sides of the wall sheets overhang the
Top Plate by 15mm as shown. Nail wall sheets to Top Plate
(two clouts per pan)
• Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheets overhang the Bottom Plate by 15mm.
• Drill & rivet Door Jamb Flashings to wall sheets using four
rivets equally spaced on each side.
STEP 4:
• Place the doors on the panel (In open position, approx
20mm below top of top plate). Using 4 x rivets, rivet the top
and bottom hinges of each door to the Door Jamb Flashing,
ensuring door closes properly.
• Fit remaining rivets.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
1854mm
15mm
15mm
10
TOP PLATE
BOTTOM PLATE
Plan View
TOP PLATE
DOOR OPENING
705mm
1460mm
x3
x3
x3
x3
x3
x3
.
1854mm
TOP
PLATE
NAIL
DOOR
JAMB
15mm
15mm