Duratuf PG96 Montageanleitung Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Lagerung im Freien Duratuf PG96 herunter. Duratuf PG96 17 Seiten. Base size: 3.020m x 2.020m

Seite drucken

ROOF ASSEMBLY CONT...

STEP 3:

• Ensure shed is sitting level and square.

• Beginning from the left hand end (looking from front)

centralise the Roof sheets on the Ridge Beam.

• Ensure that the Roof is tight against the Gable Wall Sheets. Screw 1 x 50mm Roofing screw through the 1st pan into

the Ridge Beam. (a - fig.2).

• At the back left hand corner, (from front) line up the ribs on the Roof Sheet with the ribs on the Wall Sheet then using

1 x 50mm Clout, predrill and nail Roof Sheet through the rib into the Top Plate. (b– fig.2.)Repeat at the front left hand

STEP 4:

• Centralise the Roof at the other end (R/H end) with the Ridge Beam.

• Using 1 x 50mm Roofing Screw, fix roof sheet though the pan, to the other end of

Ridge Beam. (d–fig.2).

• Using 2 x 50mm Clouts fix sheet though rib to front & back Top Plates. (e–fig.2).

• Ensure that the Ridge Beam is straight, screw roof sheets to ridge beam beside

each overlap, through the pan using 5 x 50mm Roofing screws.

• Ensure the Front and Back Top Plates are straight. Screw the roof sheets to the

front & back Top Plates, through the ribs, using 1 x Roofing Screw per rib. (fig.1).

STEP 5:

• Place barge flashings on roof at end of

shed ensuring the diagonal trimmed end

is facing out. (See diagram on pg. 5)

• Rivet the Barge Flashings to the roof

and the side wall, using four rivets on top

of barge and four into the side (fig.3).

STEP 6:

• Rivet the 2 Ridge Caps together using 4

x rivets, so total flashing is 3.050m long.

Rivet the Ridge Cap to the centre of the

roof using 10 x rivets as shown (fig.2).

STEP 7:

• Place spouting in position and rivet to

Barge Flashings at each end and rivet to

roof sheets (1 rivet per 1 sheet) (fig.4).

IMPORTANT

Use 50mm Clouts only on ribs covered by flashings,

shown in fig.2. Predrill holes using a 3.5mm drill bit.

Use Roofing Screws on all other ribs and pans.

Ensuring screws are not overtightened as this can dam-

age the seals and cause the shed to leak.

Barge

X 4

fig.3

BOTTOM PLATE

RIDGE BEAM

X 4

Spouting

Pan

Rib

fig.1

= Clout

= Screw

fig.2

fig.4