DURAVAC CVWM510 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Staubsauger DURAVAC CVWM510 herunter. DURAVAC CVWM510 14 Seiten. Wet/dry vacuums

•

Do not hang from or sit on the mounting rack

•

Do not exceed 40 pounds of maximum weight limit.

6. Insert the hose holding rod into the two holes located on the top of the mounting rack. Make sure the

bend of the rod is directed away from the wall. (fig. 6)

7. Select a location on a wall stud that is not more than 20 feet away from an electrical outlet.

8. Align the three screw holes so that they are over a stud. Make sure the rack is level and mark the whole

locations. Make a 1/8-inch diameter pilot hole in each marked location. Secure the mounting rack to the

wall stud with the three screws provided. (fig. 7)

MOUNTING THE VACUUM ON TO THE RACK

1. Measure the distance from the top screw hole of the mounting rack to the closest electrical outlet and

add 12 inches. This is the amount of cord needed; wind the excess power cord around the cord wrap

area located on the rear of the vacuum. Make sure the cord is not wound to the hanging hook (A).

(fig. 8 & 9)

2. Mount the vacuum onto the mounting rack by aligning the vac hanging hook (A) with slot (B) on the

mounting rack and slide downward until it locks. Make sure the cord is not caught between the hanging

hook (A) and the hanging slot (B). (fig. 10)

3. Attach the tool caddy on either side of the vac onto the hooks provided. (fig.11)

4. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed refer to page

11 for filter installation.（fig. 12 & 13）

5. For wet vacuum cleaning, install the supplied foam filter. (fig. 14) See page 11 for filter installation.

6. Place the power head back on the container, and secure into place using the 2 side latches. (fig. 15 & 16)

7. Insert the locking end of the hose into the port of the container and lock in place. (fig. 17)

8. Choose the desired accessories and push onto the suction tube. (fig. 18)

POLARIZED PLUG

To reduce the risk of electrical shock, this appliance has a polarized plug (with one blade wider than the

other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse

the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the

plug in any way. Double insulation

grounded power supply system.

DISMOUNTING THE VACUUM FROM THE RACK

1. Disconnect the power cord from the electrical outlet. (fig. 1)

2. Press the release lever with your left hand. (fig. 2)

3. Lift the vacuum up and out of the rack by the handle with your right hand. (fig. 3)

eliminates the need for the three wire grounded power cord and