4-Max Inspiration F3A 50E Montageanleitung Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Spielzeug 4-Max Inspiration F3A 50E herunter. 4-Max Inspiration F3A 50E 9 Seiten.
Seite drucken
Step 1
Dry fit the Horizontal stabilizer to the
fuselage and trim/adjust if necessary to get
a good fit.
Step 2
Apply foam safe glue to the top and bottom
of the fuselage opening as per the photo.
Step 3
Slide the horizontal stabilizer in place, make
sure it is square to the fin and fuselage and
allow to dry.
Step 4
Dry fit the rudder to the fin and trim/ adjust
if necessary to get a good fit. Make holes in
rudder for pin hinges.
Step 5
Apply a little petroleum jelly to just the
centre of the pin hinges (to stop the glue
from seizing them up)
Apply foam safe glue to three slots and pin
hinges on the tail of fuselage.
Step 6
Glue the 3 pin hinges in the rudder first,
ensuring the are at the correct angle
Apply glue to the three rudder connectors
and pin hinges, DO NOT apply glue to the
tail wheel wire. Insert into the pre-cut
slot/holes in the rudder. Make sure the tail
wheel wire is also inserted in the rudder
when gluing the rudder on. Ensure no glue is
on the centre part of the pin hinges
www.4-Max.co.uk
Tel: 01256 782 512