Addonics Technologies AESN4DA25-N Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Disk-Array-System Addonics Technologies AESN4DA25-N herunter. Addonics Technologies AESN4DA25-N 4 Seiten. 2.5” snap-in disk array

Seite drucken

Adding and removing hard drives from the Snap-In Disk Array

Step 1. Be sure the lock on each drive door is in an unlock position. If

not, use the key that comes with the Disk Array to unlock the drive door.

Pull on the door lever to swing open the drive door all the way.

Step 2. Slide a 2.5" SATA hard drive into the drive slot with the drive

connector side facing in. Be sure to insert the hard drive with the hard

drive label facing up. The drive should slide all the way into the slot with

very little resistance. Forcing the drive into the slot will cause drive

damage or permanent damage to the Disk Array.

Step 3. Once the drive is all the way into the drive slot, close the door all

the way till the drive door latch securely. This will engage power and data

connection with the hard drive. The LED lit for the drive slot should lit if

the Disk Array already powered on. You may lock the drive door with the

key.

Step 4. To remove the hard drive from the Disk Array, simply follow the

step 2 – 3 in reverse.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/