Addonics Technologies RAID Tower XIII RT134SDMS Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Disk-Array-System Addonics Technologies RAID Tower XIII RT134SDMS herunter. Addonics Technologies RAID Tower XIII RT134SDMS 10 Seiten.

Seite drucken

Installation

1. Be sure front and rear power switches are in

the OFF position.

2. Connect power cord to the unit.

3. Connect the Mini SAS cable from the back of

the RAID Tower to the computer.

4. Turn on main power switch on the back of the

unit. The power switch on the front may be

used for normal operation.

Installing drives into the

RAID Tower XIII

1. Be sure the lock on each drive doors is in

an unlock position. If not use the key that

comes with the Disk Array to unlock the

drive door. Pull on the door lever to swing

open the drive door all the way.

2. Slide a 3.5" SATA hard drive into the drive

slot with the drive connector side facing

in. Be sure to orient the hard drive

correctly as shown in the yellow label on

the inside of the drive door – with drive

door swing open at the bottom, the top of

the hard drive should face to the right.

The drive should slide all the way into the

slot with very little resistance. Forcing the

drive into the slot will cause the drive

damage or permanent damage to the Disk

Array.

3. Once the drive is all the way into the

driver slot, close the door all the way until

the drive door latches securely. This will

engage power and data connection with

the hard drive. The LED light for the drive

slot should light if the Disk Array already is

powered on. You may lock the drive door

with the key.

4. To remove the hard drive from the Disk

Array, simply follow the steps 2-3 in

reverse.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Mini SAS Connector

Rear Power Switch

Insert Hard Drives

with top facing

right

Phone: 408-453-6212

Email: www.addonics.com/support/query/