Addonics Technologies S4SHU3 Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Disk-Array-System Addonics Technologies S4SHU3 herunter. Addonics Technologies S4SHU3 11 Seiten. Sapphire snap-in disk array with esata & usb 3.0
Seite druckendefined, individual units will be considered spare.
RAID 0 and LARGE arrays are not fault-tolerant and spare drives will not
be useful; therefore, disabling EZ for these arrays is recommended.
When a spare drive is present and a fault-tolerant RAID (1, 10, 3, or 5) is
defined, EZ mode will automatically rebuild any available spares into the
array to replace a failed member.
Configuring the Port Multiplier Using Dipswitches
Resetting the RAID
NOTE: This procedure destroys all RAID data. It should not harm
individual drives or their contents; however, creating backups of all data
is strongly recommended before proceeding.
Be sure the port multiplier is connected to an active host before proceed-
ing. The port multiplier will not complete the process if it has no host
connection.
1. Power down the unit and set the dip switch to the desired RAID Mode.
2. While holding the SET button, turn the unit on. A long beep will sound
from the Port Multiplier. The SET button may be released once the long
beep starts.
Shortly after releasing the SET button, the port multiplier should "chirp" to
indicate the process is complete. If instead of a chirp the Port Multiplier
sounds a series of short beeps, an error has occurred during the
process.
Setting or Modifying the RAID Mode
NOTE: Setting or modifying the RAID mode destroys all data.
Be sure the port multiplier is connected to an active host before proceed-
ing. The port multiplier will not complete the process if it has no host
connection.
1. Follow the procedure for resetting the RAID Mode.
2. Power down the unit and set the dip switch to the desired RAID Mode.
3. While holding the SET button with a ballpoint pen, turn the unit on. A
long beep will sound from the Port Multiplier. The SET button may be
released once the long beep starts.
Shortly afterward, the port multiplier should "chirp" to indicate the
process is complete. If instead of a chirp the Port Multiplier sounds a
series of short beeps, an error has occurred during configuration of the
array.
BZS Switch (SW1:1):
The BZS switch is used to silence the audible alarm buzzer. The OFF
position permits the audible alarm, and the ON position silences the
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/