Apollo Smoke Detector XP95 Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssensoren Apollo Smoke Detector XP95 herunter. Apollo Smoke Detector XP95 18 Seiten. Input/output unit
Auch für Apollo Smoke Detector XP95: Installations- und Wartungshandbuch (4 seiten), Installationshandbuch (2 seiten), Installationshandbücher (2 seiten), Installationshandbuch (2 seiten), Schnellstart-Handbuch (2 seiten), Schnellstart-Handbuch (5 seiten), Installationshandbuch (2 seiten)

Apollo Smoke Detector XP95 Installationshandbuch
Receiver
LED
Rx
Tx
Rx
!
NO
FLASH
Rx
Tx
www.acornfiresecurity.com
7. Move the transmitter left, right, up, down until the LED on the receiver
fl ashes fast. Hold the transmitter in this position.
fast fl ash
slow fl ash
8. Reduce the signal strength by turning the potentiometer slowly clock-
wise until the receiver stops fl ashing.
9. Move the transmitter from right to left, in order to see if the receiver
LED can be made to fl ash fast again. If it can, repeat step 8.
Repeat this procedure but this time move the transmitter up and
down.
10.The beam detector is correctly aligned if there is no fl ash after carrying
out the movements described.
To confi rm the correct alignment of the detector move the transmitter
slowly up, down, left and right. Each movement should cause the LED
in the receiver to fl ash slowly. Leave in centre position with no LED
fl ashing.
11. Tighten the securing bolts and screws of the transmitter, making sure
it does not move and replace the plug covering the potentiometer.
Failure to replace the plug may result in false alarms due to ingress
of contaminants.
12
www.acornfiresecurity.com
signal too strong
signal too weak
no fl ash
signal correct