Apollo 3500 ETL Fehlersuche

Blättern Sie online oder laden Sie pdf Fehlersuche für Toröffner Apollo 3500 ETL herunter. Apollo 3500 ETL 3 Seiten.

The Apollo 835/836 board is the standard board in all ETL compliant Apollo Gate Operators.

Single gate systems use the 835 board (distinguished by MASTER and EMERGENCY BYPASS

modular receptacles) and DUAL gate systems use the 836 board (distinguished by MASTER,

SLAVE and EMERGENCY BYPASS receptacles). The 836 board may be used in single gate

applications by simply turning PROGRAM SWITCH #3 to the OFF position and only using the

MASTER receptacle of the board.

The Apollo 3500 ETL (single gate) and 3600 ETL (dual gate) systems uses a 12 volt - direct

current motor connected to an articulating arm mechanism for opening gates up to 20 feet and

800 pounds per gate. Keep in mind that 3500/3600 operators do NOT utilize the "SMART

ACTUATOR" feature of the 835/836 board - so Program switch #10 must ALWAYS be in the OFF

position.

Trouble Shooting the Apollo 3500/3600ETL systems:

1. Check your battery! The battery in your gate operator is the power source for the entire

system. If it is not adequately charged, the system will not operator properly. Test the

battery by checking the voltage with a volt-meter while the battery is under load (gate

operating). For AC charged systems – unplug the battery charger before load testing

battery. Battery voltage should be 11.5 volt DC or higher while the operator is running

(battery under load).

2. Program Switch Settings: At the upper center of the board there are 10 program

switches. These switches enable and disable certain features of the Apollo system.

DEFAULT setting of these switches is as follows: SINGLE GATE – 1,2,3,5 ON (all others

OFF) DUAL GATE – 1,2,5 ON (all others OFF)

3. LED ENABLE BUTTON: On the right side of the board – half way down is the LED

ENABLE button. Pressing this button once and releasing it "enables" the LEDs on the

board for approximately 15 minutes. When the LEDs are enabled – the "STOP" light

should always be lit on the left side of the board. Other LEDs may be lit as well –

depending on the status of the operator. If the gate(s) are in the OPEN position, the

OPEN limit indicator(s) should be lit. If the gate(s) are CLOSED, the CLOSED limit

indicator(s) should be lit. (The OPEN and CLOSED LEDs should never be on at the

same time) Any LEDs that are lit on the left side of the board or at the lower right corner

of the board (except the STOP LED) indicate a TRIGGER from an accessory device

connected at that location. Devices connected where an LED is lit should be removed

before further testing is done. After the system is made operational – these devices may

be reconnected one at a time. Check for proper system operation after each connection.

4. Current Sensitivity: At the top center of the board is the "Current Sensitivity" adjustment.

It adjusts the amount of force the operator will exert before it senses an obstruction. As

the wheel is turned counter clockwise, the operator will reverse more easily. As the

wheel is turned clockwise, the operator will push harder. Any time the system

"CURRENT SENSES" it will stop and reverse for two (2) seconds. If the system

"CURRENT SENSES" a second time before fully opening or closing – it will again reverse

for two (2)_seconds and then go into a HARD SHUTDOWN (see below). Sensitivity

should be set to a level that is sufficiently strong to open and close the gate in all

conditions – yet still sensitive enough to be safe. A good starting point is the one o'clock

position.

APOLLO 3500/3600 Troubleshooting