Dashbon Flicks Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Tragbares Stereosystem Dashbon Flicks herunter. Dashbon Flicks 11 Seiten.
Auch für Dashbon Flicks: Schnellstart-Handbuch (10 seiten)

Seite drucken

User´s Manual

Proceed as follows to avoid any moisture build-up:

Seal this device in a plastic bag before moving it to another room, in order

for it to adapt to room conditions.

Wait one to two hours before you take the device out of the plastic bag.

The device should not be used in a very dusty environment. Dust particles and other

foreign objects may damage the unit.

Do not expose the device to extreme vibrations. It may damage the internal

components.

Do not allow children to handle the device without supervision. The packing materials

should be kept out of the hands of children.

REPAIRS

Do not repair the device yourself. Improper maintenance can result in injuries or

damage to the device. Your device must be repaired by an authorised service centre.

Find details of authorised service centres on the warranty card.

Do not remove the type label from your device; this would void the warranty.

AUTOMATIC DEVICE TEMPERATUR CONTROL

This device includes an automatic thermal management controller. If the internal

temperature gets too hot, the Fan speed will automatically increase (noise increase)

and the product will automatically turned off.

POWER SUPPLY

Before turning on your device, check that the outlet that you are going to plug it into

conforms to the indications shown on the information plate (voltage, current, power

network frequency) located on your device. This device shall be connected to a single

phase power network. The device shall not be installed on bare ground.

Only use the power cable that is supplied with your device. Your device is delivered

with a grounded power cord. It is imperative to connect a grounded connector to a

grounded outlet connected to the building earthing.

The socket outlet shall be installed near the equipment and shall be easily accessible.

In case of failure, turn off the master switch and disconnect the power cable from the

electrical outlet.

Turn off the device and unplug from the power outlet before cleaning the surface. Use

a soft, lint-free cloth. Never use liquid, gaseous or easily ammable cleansers (sprays,

abrasives, polishes, alcohol). Do not allow any moisture to reach the interior of the

device.

High Power LED

This device is equipped with high power LED

(Light Emitting Diode), which emits very bright

light. Do not look directly into the projector lens.

This could cause eye irritation or damage.

DANGER!

Page 3