Apollo Sprayers MAXI-MISER PBC7600-GTO Gebrauchsanweisung - Seite 12

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Farbspritzgerät Apollo Sprayers MAXI-MISER PBC7600-GTO herunter. Apollo Sprayers MAXI-MISER PBC7600-GTO 20 Seiten.

Seite drucken

Using the back end of the needle, move the distributor plate so that the round screw

hole is at the 5 o'clock position. DO NOT put the distributor plate and fan adjustment

ring together as show in the picture marked "incorrect". You will only be able to

achieve a round spray pattern.

1. Place the Air Distributor (#6) on top of the paired fan adjustment ring and Air

Distributor plate.

2. Align the screw hole in the Air Distributor with the holes in the fan adjustment ring

and air distributor plate.

4. Screw the fluid nozzle (#3) back onto the spray gun, finger tight. Rotate the fan

adjustment ring to be sure it rotates freely and easily. Tighten the nozzle slightly more

with the wrench (spanner). Rotate fan adjustment ring again. Do not over tighten the

fluid nozzle as it will stop the fan adjustment ring from rotating. If too tight, back off

slightly. Be sure that the fluid nozzle is not too loose or leaking will occur.

3. Place the Air Distributor onto the body of the

spray gun aligning the pin with the hole in the

spray gun body at the 5 o'clock position.

Insert the air cap seal (#4). To insert, observe both sides of the seal. One side should

have three small circles. This side goes toward the spray gun. Snap the air cap seal onto the

air distributor (#6).