Apollo Ultrasonic Visual Kurzanleitung
Blättern Sie online oder laden Sie pdf Kurzanleitung für Prüfgeräte Apollo Ultrasonic Visual herunter. Apollo Ultrasonic Visual 4 Seiten. Oil level monitor
Auch für Apollo Ultrasonic Visual: Kurzanleitung (4 seiten)
Seite drucken
First Stage
FOR TANKS OF 800mm AND MORE THAN 1 METRE IN HEIGHT – Continue Matching To Second Stage.
Second Stage – Tank Height Look Up Table For Apollo Visual – Bar Display
Visual
Transmitter
Reading
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 800mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1000mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1100mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1200mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1300mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1400mm
YOU MAY NOW FIT THE TRANSMITTER TO YOUR TANK.
tank. Tighten on to the tank using the 2 screws supplied. Do not over tighten.
DUN0708
QUICK GUIDE
Step 1: Measure the tank height and from the height chart, set the relevant switches on the
receiver. Using a screwdriver or tip of ball point pen, flip the relevant switches upwards (=ON).
e.g. Tank height 850mm set switches 1, 4 & 8.
Step 2: Plug receiver into a suitable and convenient electrical socket and switch on. The display
screen on the front of the receiver will show a flashing top bar. This indicates that the receiver is
awaiting a unique code. The flashing top bar will last for 2 minutes during which time you can
match the transmitter to the receiver.
Step 3: Hold the Visual transmitter against/touching the receiver on the right hand side, so that
the black dots are aligned/touching each other, with the label side facing the receiver, as shown.
Hold together for about 20 seconds to allow the unique code to be transferred. The bars will
increase up the display screen. ONLY when all 10 bars are shown, will they flash to indicate that,
the unique code is transferred. For tanks of 1 metre in height, the matching is now complete.
Separate the Apollo Visual from the receiver and watch for double flash of red light on the Visual
transmitter. You may now fit to tank.
Set Measurement
NO BARS
1 BAR
2 BARS
3 BARS
4 BARS
5 BARS
Visual
Transmitter
Reading
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 1700mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 2000mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 2300mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 2600mm
If you hold Visual Transmitter until you see this, you
will have set it to measure tank height 2800mm to
Don't forget that if you make a mistake, you can
simply continue to hold Visual transmitter in
matching position until the bars reset themselves
Ensure the Visual transmitter is vertical on top of the
Apollo Instructions
9-5396-02
Set Measurement
6 BARS
7 BARS
8 BARS
9 BARS
3000mm
10 BARS
and start again.