DURAVIT Universal LM 7867 Montageanleitung - Seite 3
Blättern Sie online oder laden Sie pdf Montageanleitung für Körperpflegeprodukte DURAVIT Universal LM 7867 herunter. DURAVIT Universal LM 7867 7 Seiten.
Seite drucken
Important information
Intended use
The mounting instructions come as part of the Duravit
product and are aimed at people who carry out the
electrical installation for the product. You must read
through the mounting instructions carefully and they must
be available at all times.
Target readership and qualifications
The electrical installation may only be carried out by
qualified electricians.
Protection rating of Duravit products
The protection rating of Duravit products with a power
supply complies with the IP 44 standard as a minimum.
Protection class of wall lights
Protection class
Connecting cable
II
H03VV-F, 2x 0.75 mm
Energy label
Standards and directives
Duravit products comply with the CE marking
directives:
Icons and symbols
Symbol
Meaning
This symbol highlights useful and important
information.
>
Action required
Instructions for use
• The bathroom furniture range complies with the
standards and guidelines applicable at the time of
delivery and is designed for use in bathrooms.
• Direct contact with water should be avoided, for
example, when showering.
• A power supply of 110 V – 230 V must be available on
site.
Safety instructions
Danger to life
Contact with electricity may lead to an electric shock.
> Carry out the electrical installation in accordance with
the national, European and international directives and
standards.
> Observe protection zones for wet rooms in accordance
with country-specific standards, local regulations and
low voltage guidelines.
> Connect the electrics using a ground fault circuit
interrupter (GFCI) in wet rooms or other specially
equipped rooms.
> Disconnect electrical components from the power supply
before the installation.
> Check that all components are de-energised.
> Prevent the power supply from being switched on
accidentally.
Penetration of foreign bodies and water
Foreign bodies or water in equipment lead to a short circuit
2
that may cause damage to the product.
> Observe country-specific protection zones for wet
rooms.
Measuring mode
The control unit has a measuring mode. Once the
measuring mode is active, the light is switched on again
automatically 90 seconds after it has been switched off.
The measuring mode may be triggered during an
installation under voltage by accidentally actuating
the touch LED/infrared switch continuously.
> Actuate the touch LED/infrared switch for longer than
65 seconds to activate the measuring mode. Use a
reflective object (paper) for the infrared switch.
The light flashes 6 times.
> Actuate the touch LED/infrared switch again for more
than 65 seconds to deactivate the measuring mode. Use
a reflective object (paper) for the infrared switch.
The light flashes 4 times.
5