Duren 321286 Produkt-Bedienungsanleitung - Seite 5
Blättern Sie online oder laden Sie pdf Produkt-Bedienungsanleitung für Sander Duren 321286 herunter. Duren 321286 9 Seiten. Duren 321286 electric 240v 180mm polisher
Seite drucken
321286_Product Instructions 28/11/2013 16:30 Page 5
PLEASE KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE
Operating Instructions
During Use
1
When using the polisher for long periods of time, check the polishing pad for wear.
2
Replace worn pads as worn or clogged pads will make the polisher inefficient.
3
The polishing operation will cause heat. Check the material that is being worked on that
it is not getting too hot. If this is occurring, stop polishing to allow the material to cool
down.
4
You can adjust the speed of the tool by adjusting the pressure you apply to the throttle.
5
Make regular checks on the polishing pad for wear and damage and replace them
immediately.
6
Due to the potential heat caused by the polishing process, keep flammable liquids and
gases well away from the work area.
Maintenance
1
Remove plug from the mains power supply before carrying out any maintenance or cleaning.
2
Every 50 hours of operation blow compressed air through the motor while running at no load to clean
out accumulated dust. If operating in especially dusty conditions, perform this operation more often.
3
Periodically blow out all air passages with dry compressed air.
4
All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts.
They could possibly dissolve or otherwise damage the material.
5
Wear safety glasses while using compressed air.
Carbon Brushes
1
The carbon brushes are a normal wearing part and must be replaced when they reach their wear
limit. NOTE: Checking and replacing the carbon brushes should be entrusted to a qualified service
centre. The carbon brushes furnished will last approximately 50 hours of running time or 10,000 on/off
cycles. Replace both carbon brushes when either has less than 1/4" length of carbon remaining.
2
To inspect or replace brushes, first unplug the machine.
3
Use a flat blade screwdriver to remove the cover, then remove the brush to inspect or replace.
Replacement is the reverse of removal. Repeat the process with the other brush, always replace
brushes in pairs.
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk