Appareo Stratus 2i Installationshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationshandbuch für Empfänger Appareo Stratus 2i herunter. Appareo Stratus 2i 7 Seiten. Ads-b receiver

Installing the interface cables

NOTE: For instructions on installing Stratus ES/ESG, reference the Stratus ES/ESG Installation

Instructions (Appareo document number 600840-000031 for TSO installations and

600840-000032 for STC installations). These documents can be found on the Aviation Dealer

Portal.

1. Wire the 9 pin D-Sub connector to the transponder following the wiring diagram on

Page 5, allowing for a maximum harness length of 3 feet. Use 20 gauge wire for this

harness.

2. Mate this 9-pin D-Sub connector with the Stratus 2i power serial interface cable and

secure using the thumb screws.

3. Attach the BNC blind mate adapter to the ADSB AUX hole on the transponder backplate.

4. Attach the BNC connector of the Stratus 2i RF interface cable to Stratus ES/ESG's

ADSB AUX port.

5. Connect the remaining end of the power serial cable into the power port of Stratus 2i

(marked by the power symbol).

6. Connect the remaining end of the Stratus 2i RF interface cable into the ADS-B port of

Stratus 2i. Secure cables as necessary.

7. Power on the aircraft to ensure that Stratus 2i is receiving power. Refer to the LED

indicator statuses on Page 7.

The transponder must be configured to allow for ADS-B In receiver information from the cockpit

after Stratus 2i has been placed in the aircraft.

1. Enter into configuration mode on the transponder (while holding the FUNC key, press

and release the PWR key).

2. Press FUNC or the arrow keys to navigate to the "ADS-B Capability" screen and press

ENT.

3. Use the arrow keys to set the capability to UAT and 1090 ES (the frequencies Stratus 2i

is capable of).

4. Press ENT.

Once it is receiving aircraft power, Stratus 2i will automatically turn on. All LED indicators will

briefly illuminate red and then green as the receiver powers on and auto-calibrates. If Stratus 2i

is moved after being turned on, it must be re-calibrated in ForeFlight Mobile.

600840-000033 Stratus 2i Installation Guide

Last Revised: September 5, 2017

Revision 2.0

Page 4 of 7