Durite 0-649-40 Technische Daten - Seite 5

Blättern Sie online oder laden Sie pdf Technische Daten für Fernstart Durite 0-649-40 herunter. Durite 0-649-40 7 Seiten.

1. Connect the USB cable with the UK plug and then plug it into the universal socket.

2. Connect the Micro connector to the 0-649-40.

1. Before jump starting the vehicle make sure the jump pack has at least 60% battery.

2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK

clamp to the vehicle's battery negative(-) terminal.

3. When jump starting a 12V vehicle the LCD screen displays "12V JUMP START READY'; when

jump start 24V vehicle the LCD screen displays "24V JUMP START READY'; Please note that

if the battery is too low for voltage auto detection then please manually select voltage by

pressing and holding either 12V or 24V button for 3 seconds dependent on the vehicle you are

trying to start.

4. Start the vehicle

5. When the vehicle is started, remove the jumper cable from Jump Starter and disconnect RED

and BLACK clamps from the vehicle battery. Leave the vehicle's engine running.

Please Note: For 12V vehicle auto detection the voltage range is 5V~15V (Voltage of car

battery)

For 24V vehicle auto detect voltage range is 17V ~ Voltage of battery pack, so the lowest

voltage for 24V vehicle auto detection is 17V. If the car voltage is within the range of 15V-17V ,

the auto detect system will not apply and there will be no action. The user should apply manual

operation

CHARGING

JUMP STARTING