AddSecure Edge VS5051 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Intercom System AddSecure Edge VS5051 herunter. AddSecure Edge VS5051 10 Seiten. Connect intercom
Auch für AddSecure Edge VS5051: Benutzerhandbuch (14 seiten)

AddSecure Edge VS5051 Benutzerhandbuch

9.1 Communication test

10 Maintenance routine

10.1 Periodic check of communications

10.2 Maintaining data

10.3 Confirm current status

10.4 Periodic battery check: For the VS5051

PDK-15088-v.2.0 Connect Intercom User Manual.docx
assistance. If all the LEDs are correct, a simple communication test should
be run, see section 9.1 below.
To perform a simple communication test, one of the intercom buttons must
be set to call your mobile phone.
Start the test by pressing the reprogrammed intercom button. Your mobile
phone should ring and display the intercom screen. Respond by clicking
«Open the door». If the door lock unlocks, this indicates that there is clear
two-way communication.
After the test, the intercom button must be reprogrammed back to the
correct telephone number.
Maintenance routines are as follows:
 Periodic check of communications.
 Maintaining data.
 Confirm current status.
 Periodic battery check (VS5051 only).
This is simply to ensure that the terminal is still online. Check that the
Cellular LED, marked "CEL" (3 in section 5 "Board configuration") is lit. If it
is, cellular connection is good. If it is not lit, troubleshoot your cellular
signal.
To change phone numbers, refer to the manual for the intercom panel.
AddSecure maintains information about account numbers and information,
based on input from the owner or service partner. To make changes to this,
contact AddSecure.
Check the status by checking the LEDs on the lid of the unit.
When a LED is lit, that indicates that this particular function is working
correctly. For details, see section 9 "Commissioning".
The status of the battery should be manually checked periodically even
though the battery status is continuously tested automatically. If the self-
test finds the battery faulty, the Power LED will flicker, (see section 9
"Commissoning") and a message will be sent through AddSecure Connect
to the ARC. The battery should then be replaced with a new battery from
AddSecure.
page 7