DUROFIX RI2036A3 Produktinformation Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Produktinformation Handbuch für Schlagschrauber DUROFIX RI2036A3 herunter. DUROFIX RI2036A3 16 Seiten. Brushless impact wrench
Seite drucken
BUILT-IN LED LIGHT
A built-in LED light can illuminate the work area and improve vision when
drilling/driving in areas with insufficient light.
ELECTRIC BRAKE
The variable speed switch is equipped with a circuit design electric of brake function.
The tool will consistently operate to quickly stop rotating after the switch release.
BATTERY POWER INDICATOR
Trigger the tool and Battery Indicator to show the battery pack's remaining capacity
1.
One light ON: 30% remaining capacity.
2.
Two lights ON: 60% remaining capacity.
3.
All lights ON: 100% remaining capacity.
NOTE
Always check the direction of the rotation before use.
NOTE
Due to the auto shut-off function, if tool is repeatedly operated on and off
in a short time frame, the MCU will determine it as being over current resulting in
tool shut down. This phenomenon occurs most frequently in the first torque stage.
1.
After continuous use, allow the impact wrench to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
2.
Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
3.
Apply forward pressure to the tool to prevent the socket from slipping off the bolt.
4.
To start, turn impact wrench/driver on. Always check torque with a torque wrench.
The fastening torque can be affected by many factors including the following:
Voltage: Low voltage due to a nearly discharged battery will reduce the fastening
torque.
Socket Size: Failure to use the correct socket size will cause a reduction in fastening
torque.
Variable Speed Trigger Switch: Operating the tool at a reduced speed will reduce the
fastening torque.
-12