Data-Linc Group FLC910E Schnellstart - Seite 4
Blättern Sie online oder laden Sie pdf Schnellstart für Funk-Modems Data-Linc Group FLC910E herunter. Data-Linc Group FLC910E 4 Seiten. Fastlinc 905-925 mhz ofdm industrial ethernet radio modem
Seite druckenFLC910E Quick Start Guide
Configuring the "Station Adaptor"
•Select [Radio] to configure the RF transceiver operation:
•Select "Station Adaptor" as Operating Mode
•Click the [Apply] button at the bottom to save.
If the "Base Station" Broadcast Wireless Network Name (SSID) is set to yes:
•Click the [Site Survey] button to join the Base Station ID.
Note: Bandwidth must be set the same for the "Base Station" and "Station Adaptor" to connect and to be viewable
by the Site Survey.
•Click the [Edit] button to setup the VBS/VLAN settings.
•Select Security Profile Sta_Profile and click the [Edit] button.
•Change the "Network Authentication: " to "WPA2-PSK" to match the "Base Station" configured as above.
•Set the "WPA Passphrase (Network Key):" to match the "Base Station.
•Click [Apply] button at the bottom to save.
•Select [Basic Setup] to configure the IP Address settings
Change the Device Name (if desired for a more recognizable name).
Change the "IP Address"
Note: All the units and equipment on the network will need unique IP addresses or use a DHCP server to
assign an address). Note: When the settings are applied the IP Address will be changed. To continue
configuration changing the PC IP Address may be needed.
•Click [Apply] button at the bottom to save.
This unit is now configured as a "Station Adaptor" to communicate to your "Base Station".
Note: The RSSI indication on the "Station Adaptor" will indicate the signal strength of the received "Base Station"
wireless signal.
Testing
To verify connectivity a simple ping command can be used. Ping a device on the LAN connected to the opposing
FLC910E or the FLC910E modem itself. For more detailed information or troubleshooting information please refer to
the user's guide.
PN 161-09855-001A
June 2010