ELRO AS80MA11 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Sicherheitssensoren ELRO AS80MA11 herunter. ELRO AS80MA11 4 Seiten. Magnetic detector

Seite drucken

Troubleshooting

The troubleshooting table lists some possible causes and solutions. Please contact

your original retailer or nearest service center if the below solutions cannot solve

your problem.

Symptom

Cause of Failure

LED does not light up 1. Run out of battery

power.

2. Reverse battery

polarity.

With battery cover

1. Check if detector has

removed (Test mode),

completed binding with

the LED lights up but

Gateway.

there is no response

from gateway.

2. Cannot communicate

Reset to Factory Settings

To reset back to factory default state:

(1) Press and hold the Tamper switch for 3 seconds until the LED flashes

moderately. Release the button. The unit enters code binding mode and a 30-

second countdown starts.

(2) Within the 30-second countdown, press and hold the link button for more than 6

seconds until the LED turns off.

(3) Remove the batteries and re-insert them again. If the LED blinks slowly for 30

seconds this implies the device is reset back to factory mode.

Specifications

Battery

Operating Temperature

Frequency Range

** Specifications are subject to change without notice.

Recommendation

1. Remove the battery cover to

enter hardware test mode.

Remove the magnet and the LED

should light up.

If not, replace the replace the

battery.

2. Refit the battery with correct

polarity.

1. Follow the steps for Manual

Binding

2. Place the magnetic detector

closer to the gateway.

CR2450 3.0V 620mAh Lithium battery

-10°C to 40°C

868MHz

WARNING:

Do not dispose of electrical appliances as unsorted municipal waste, use separate

collection facilities.

Contact your local government for information regarding the collection systems

available.

If electrical appliances are disposed of in landfills or dumps, hazardous substances

can leak into the groundwater and get into the food chain, damaging your health

and well-being.

When replacing old appliances with new ones, the retailer is legally obligated to

take back your old appliance for disposal at least for free of charge.