DURRIDGE RAD7 Handbuch für Bluetooth-Verbindungen - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Bluetooth-Verbindungen für Sicherheitssensoren DURRIDGE RAD7 herunter. DURRIDGE RAD7 4 Seiten. Passive, slow response radon in water accessory
Auch für DURRIDGE RAD7: Handbuch Konnektivität (4 seiten), Benutzerhandbuch (7 seiten), Benutzerhandbuch (15 seiten)
Seite drucken
6. After clicking OK, select the Device Setting panel, as shown in Figure 3, below. Set the controls as
follows:
• S et the Operation Mode to MODE3 (Allow any Bluetooth devices to discover/connect to this
Parani-SD).
• Set the Device Name to "SD1000-Bluetooth" or a similarly recognizable name.
• Check the Authentication checkbox, and enter 0000 in the Pin Code field. Uncheck the
Encryption checkbox.
• Set Command Response to OFF. This makes it possible to for the SD1000 adaptor to operate
without disrupting the RAD7. Notice: If Command Response is left ON, the RAD7 may
become corrupted and inoperable.
• Make sure the Baud Rate is 9600, Parity is None, and Stop Bit is 1.
Figure 3: The ParaniWin Device Setting Panel: This panel is used to configure the SD1000 adaptor. Controls
marked with red arrows must be modified from their factory defaults in order for the SD1000 to function properly
with the RAD7.
7. After specifying the correct settings, click the Apply button, and wait for the settings to be saved.
8. Exit ParaniWin. Switch OFF the SD1000 adaptor and unplug it from the computer. It is now ready
to use with a RAD7.
3