Cayken 925/2B Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Cayken 925/2B herunter. Cayken 925/2B 20 Seiten.

FRICTION CLUTCH

Clutch carries out protection under high-strength mechanical overload

condition for operator, machine and bit. Please ensure clutch in a separation state

goes off work to do do not exceed 3-4 second, because it will cause temperature

rise quickly and causes wear for friction flat that time passes length.

After pressing switch, machine ( soft start switch ) starts smoothly.If machine

is overload, its electron protects switch, will remind operator machine to be

overload with exceptional fluctuation. If load does not be reduced , after some

seconds of clocks, switch is closed voluntarily. Start again if remove load, machine

will again start smoothly. When start machine again is former, ensure bit may turn

freely is not blocked in drill hole. It will even burn out for that generator causes

serious infringement if this machine highest compression is higher than 260 V for

260 V. When using generator to supply power , must notice that voltage peak value

cannot be higher than 260 V.

Ordinary gear speed adjustment

3 files

To improve the efficiency of drilling, some machines have 3 type gear speed chang-

es. In it is high to divide , high speed files ( the day files ) apply to little bit and more

soft material to rush , fast files ( M files ) apply to in bit and more hard material; The

files of low speed ( L files ) apply to big bit and hard material.

Machine turns under stoping the state that turns or stops soon to move group chan-

ge files.

Machine must want to shift gear to position when shifting gear , if occur main shaft

after start,it does not turn or have tooth sound to explain that files position does

not hang to position , must close switch at once, and turn again move knob to the

position that needs files at the same time round trip turns main shaft ( hang files

easily ), have obvious put into gear to block until position.

Must close mains switch at once, round trip turns mainshaft to at the same time

turn to move knob. Machine is operating at full speed, load or card please don't

change files when living.

2 files

Oil soaks money gear speed adjustment

3 files

2 files