Datalogic DS2100N Kurzreferenz-Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Kurzreferenz-Handbuch für Barcode-Leser Datalogic DS2100N herunter. Datalogic DS2100N 20 Seiten. Compact laser scanner
Auch für Datalogic DS2100N: Broschüre & Specs (2 seiten)

Seite drucken

Exit the process by pressing the X-PRESS™ push button once. The scanner will restart at the end of the

process, and then the detected barcodes are automatically configured in scanner memory.

If the barcode cannot be read because of low contrast or excessive ambient light, you can

perform the AutoSetup function to optimize the optical parameters. Then you can perform

AutoLearn to recognize the barcode symbology.

NOTE

AUTO SETUP (OPTIONAL)

At the end of the Auto Learn procedure, you can perform the Auto Setup procedure to set up the reading

parameters.

Enter the Auto Setup function by holding the X-PRESS™ push button pressed until the SETUP LED is on.

Release the button to enter the Auto Setup function.

Once entered, if a barcode label is positioned in front of the scanline, the scanner automatically performs the

optimal setup of the reading parameters for that specific barcode.

SETUP

LEARN

TEST

Figure 6 – X-PRESS™ Interface: Auto Setup Function

This procedure ends either when the barcode is successfully decoded or after a timeout of about 7 (seven) seconds.

The scanner will restart at the end of the process, and then the optimized reading parameters for that barcode are

automatically configured in scanner memory.

If your application has been configured using X-PRESS™, go to STEP 5.

NOTE

RESET SCANNER TO FACTORY DEFAULT (OPTIONAL)

If it ever becomes necessary to reset the scanner to the factory default values, you can perform this procedure by

holding the X-PRESS™ push button pressed while powering up the scanner. At the end of the procedure (about

5-6 seconds), the Configuration and Environmental parameters are reset and all LEDs blink simultaneously 3

times. If connected through a CBX500 with display module, the message "Default Set" is shown on the display.

READY

green

GOOD

green

TRIGGER

yellow

COM

yellow

STATUS

red

DS2100N QUICK GUIDE

The procedure is as follows:

A) place the desired barcode on the scanline.

B) enter the AutoSetup function (the laser turns

on and the SETUP LED blinks to indicate the

ongoing process)

C) wait until the SETUP LED stays steady on

(indicating the reader has detected the

barcode)