Cayken KCY-28DM Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Cayken KCY-28DM herunter. Cayken KCY-28DM 8 Seiten. Industrial equipment

Seite drucken

Operation Manual

WARNING

To prevent electric shock or fire please strictly abide by the procedures in the

operation manual

The machine only for the specialized persons please do not let other people to

operate If any violation of the instructions operation and cause personal injury

or machine damage our company disclaim all responsibility

The machine can only maintain by the people who has the certification

THANKS TO THE BUYER

Thank you very much for buying our company magnetic drill series products.

Please read operation manual and must pay attention to safety precaution

The right operation will make you fully feel our products superior performance

Please put this manual in a safe place for future reference

ABOUT THIS MANUAL

The machine model of the description in this manual:

KCY: 36/2WDO 48/2WDO 65/2WD 85/3WD

SCY:

32HD 42HD 68HD 98HD 126CD

KCY: 55QE

65QE 80QE

KCY:

28DM 38DM 55DM

Confirm the machine model according to the nameplate.

、DESCRIPTIONS OF PRODUCTS

Magnetic drill is a kind of electric tool for adhering and drilling on the horizontal level side

face and top face and widely used in the building bridge building and ship building industries

and so on You can use the magnetic drill when you can not use drill press and electric hand

drill to drill huge steel workpieces or in field operation It's very convenient to use flexible

can reduce labor intensity improve the machining precision and work efficiency

、CAUTIONS

1 Please read the manual carefully before use to understand the magnetic base drill structure;

electromagnetic sucker electric drill and transmission functions

2 Before installing or remove the drill must confirm the motor switch is closed and the plug

3 Using a drill bit after clamping key wrench must be removed while the drill must be sharp

for Morse taper shank drill should pay attention to the flat iron tail at the cone sleeve waist

groove insert cone sleeve Remove the drill the inclined flat iron is inserted on the oblique

iron just bit dropping hammer sleeve waist groove

4 And its operation must be put in the fuselage behind the cable away from the drill bit

5 In the switching power supply electric and magnetic switch must be in the off position

6 Drilling machine must be used when using engine coolant The use of cooling liquid soap

according to the ratio of watered absolutely can not direct use water cooling Otherwise

very easy to damage and the main internal rust on the drill bit can t get it out No internal

machine water otherwise it will burn the circuit board

7 Such as the use of the stepless speed regulation models of constant power overload prote

ction the machine during use motor suddenly stop functioning then in the function of over

load protection device the steps are as follows A turn off the power switch paused for a few

minutes; B weight of the plug then open the motor

8 The use of magnetic base drill must wear a seat belt buckle

9 No rough operation personnel feed can not handle in order to work fast and pressed down

the machine feed so lossy bit and machine

10 Non magnetic materials can not drill with magnetic base if the non magnetic material

punching need to choose the magnetic base drill with sucker

11 Cannot use at the same time electric welding machine and magnetic base drill on the same

piece of steel plate so that the operating from electric shock danger

: ,

(

)