Cayken SCY-1600 Betriebshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Bohrer Cayken SCY-1600 herunter. Cayken SCY-1600 10 Seiten.

Seite drucken
FAULT HANDING
FAULTS
CAUSES
witch contact undesirable
ower supply is broken
agnetic base
The fuse burn out
without suction
Electromagnet short circuit or burn out
dsorption not on the steel frame
Circuit board burn out
witch contact undesirable
achine did not
oint loose
run after the ump
rush and commutator poor contact
rill the armature or stator coil burn out
dsorption artifacts thin
dsorption on the surface is small
agnetic little
suction
upport bar between the adsorption surface
iode may be irtual welding
Turn the handle gu
haft key cut
ide does not work
heel and rack misplace
or a drill and a fastener is loose
rill out the
it unilateral cutting
elliptical hole
dsorption surface ha e sundry

QUALITY ASSURANCE

Consumers buy our machines produced within six months en oy free maintenance and
warranty ser ice
.
uring normal use of the whole or parts of any manufacturing process or
product failures caused by components please present the original in oice the dealer sta
,
mped and filled properly warranty certificate to the Company or the Company s designated
repair station to recei e free ser ices machine consumable normal wear and tear o erload
.
do not operate according to operating specifications disassemble damage caused as a result
of use of parts other than the Company and damage are not co ered by warranty warranty
expires pro ided by the designated repair station maintenance ser ice maintenance records
,
must be sealed or signed by the repair station to take effect
C
AYKEN
PROFESSIONAL DRILLING
ELIMINATION METHODS
epair the switch
epair the power supply
eplace the uses
epair or replace the magnetic bridge
Change the adsorption surface
Change the circuit board
epair and change switch
Check the electric drill part connector
epair or replace the electric brush
Changing the armature or stator
eplace the adsorption surface or thickening adsorption surface
eplace the adsorption surface or temporary welding
thick surface adsorption
upport bar top tight
e
elding
eplace the shaft key
nscrew the rack bottom screw remo e guide to repair
,
Correction of erticality tighten the fasteners
Grind anew
Eliminate clutter
,
,
,
,
,
,
,
.
.
.
15
www.cayken.com.cn
C
AYKEN
PROFESSIONAL DRILLING
16
www.cayken.com.cn