Cayken SCY-18/2PA Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Cayken SCY-18/2PA herunter. Cayken SCY-18/2PA 9 Seiten.
Seite drucken
FAULT HANDING
Cause
Error
The
Power off, or plug loosed
Motor
Carbon brush get stuck, and detach
from diverter
does
Reset PRCD failed
not
work
PRCD get damaged
Drill bit worn out
Feeding speed is too low
Drill bit was pasted by chips
Drill
Rotate speed is too high
Slowly
Cutting on steel and slip
Too much chips in the hole
Less water supply or water leakage Check the ball valve and the water flow
Drill bit becoming glazed
The tube and drill bit or the drill bit
and hole wall was jammed by chips
Drill bit
The stand is not secured, move location
jam
Rotate speed is too high
Cutting on steel and slip
Spindle is not straight
Drill bit
under
Drill bit is not straight
cutting
Chips can' t be flushed out of the hole
Water jacket
The seal of skeleton is worn out
is leaking
Solution
Power up, plug in
Re-install carbon brush
Push reset button or re-start the motor
Chang PRCD
Change drill bit
Accelerate feeding speed
Clean the drill bit, enhance water pressure
Change to low speed
Reduce feeding speed, after cutting through the steel,
increase it
Clean the bottom of hole and enhance water pressure
Re-sharp the drill bit with grinder
Switch off the machine, turn the drill bit right and left
with wrench or pull the drill bit out and break up the
core sample
Re-fix the stand
Narrow the gap
Repair or replace the spindle
Replace the drill bit
Enhance water pressure, pull out the drill bit, clean the hole
Change the seal
M A I N T E N A N C E
Warning: Always and on principle pull the mains plug before beginning
with works of maintenance or repairs.
Clean the machine with a dry or moist cleaning-rag and not with a jet of water, make sure
the water does not go into the motor and switch box. Keep the ventilation apertures clean, do
not forget to clean the core bit thread and grease it, get all screws checked and tighten.
Have your tool only repaired by qualified personnel and only with original spare parts. Or
else, it may cause damage to person or machine.
CARBON BRUSH
After you have used the machine for about 300 hours you should check the carbon
brushes for wear and replace them if necessary. Like any other work on the motor this
must be done by an electrical specialist.
QUALITY ASSURANCE
This product is covered by a guarantee for a period of 6 months from the date of
purchase. The guarantee covers all defects or damages of the product during the gu
arantee period evidently due the defaults in workmanship or material and is limited
to repair and/or adjustment. Please contact our company or authorized parties for
free replacement or repair.
The guarantee is not valid in case of normally wear and tear, if the product has
been misused, used contrary to the instruction manual, or by using extraneous parts.
After warranty period, authorized parties have right to ask for payback for repair, the
maintenance record effects with the stamp and signature of authorized party.
APPLICATION FIELD
This machine is applied for drilling holes in concrete, stone, masonry, and pipe work,
such as air cooler, electric appliance, water pipe and gas pipe.
Notice: In order to constantly improve products, our company reserves the
right to change technical data without prior inform.
7
8