Cayken SCY-420WEQ Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kutter Cayken SCY-420WEQ herunter. Cayken SCY-420WEQ 9 Seiten. Wall cutter
Seite druckenChapter4. Illustrations of the Machine Parts
Inlet valve
Track way
Control
Cabinet
Chapter5. Applicable Projects
The cutter is applicable for cutting or slotting on armoured
concrete, concrete brick wall,stone material such as marble
and wall.
Feed-on hand wheel
Collecting Breeching
The motor of
the cutter
The motor of the
host machine
Feed-on gear-box
Mainengine foundation
7
Chapter6. User's Notice
Check the following points before plugging in:
1.Use rated power supply
If the machine does not use rated power supply,it can not
work.Please notice that only the machine uses the right rated
power supply and keeps the current in the control cabinet at
6A,no more than 10A,the machine can work to its optimal
efficiency and without damage.
2.Make sure that the switch is in position"Off"
The switch on the control cabinet of the machine can be easily
switched on.Make sure all the switches of the cutter are off
before plugging in to avoid the accident.
3.Make sure the saw web is correctly fixed
Lock the saw web cat in the clockwise direction.Fasten it with
the open end wrench and rotate the saw web to see if it rubs with
the saw web cover.If it does,adjust the saw web and the saw web
cover before use.
Chapter7. Operational Guildeline
A.Installation of the machine
Install the track way first,and then fix the machine on the track
way.In order to cut the wall surface flatly,the right method to
install the track way is:The motor is on top and the saw web in
the downside.Keep the rotating direction of the saw web against
that of the running direction of the motor.In this case,it can
not reduce the cutting time,but also improve the cutting
capacity.
1.Drill one anchoring spurs for the setscrew of 16.3-16.5mm in
diameter and 55mm in depth with the percussion drill at the
position of133±2mm from the facet.It can hold a machine with a
M12 setscrew.The guide rail can be fixed in any place around the
anchoring spurs.
2.Use an air pressure gun to clean away the pieces in the
anchoring spurs.
3.Drive in a machine with a M12 setscrew,insert a loosening bar
into the screw hole,and knock the fixed setscrew with a
hammer.Make sure the setscrew is fixed tightly in the holes,or
else it may move or drop down in operation.Use the outfitted
setscrew and screw and so on to fasten the
8