Dust Free BIO-FIGHTER Ultra-Flex 1S Handbuch für Installation und Betrieb - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Beleuchtungsanlagen Dust Free BIO-FIGHTER Ultra-Flex 1S herunter. Dust Free BIO-FIGHTER Ultra-Flex 1S 7 Seiten. Ultraviolet light systems

Seite drucken

BIO-FIGHTER® ULTRA-FLEX INSTALLATION & OPERATION MANUAL

Important:

The device must be installed in compliance

with all national and local electrical and

mechanical codes. Failure to do so will void

Dust Free® warranty.

MOUNTING THE BASE

Remove the cover and place the base at the

desired location. Use the included mounting

screws to install the base to the surface.

Replace the cover after the base is mounted.

Fig. 1 Use included mounting screws to install device at desired

location.

REMOTE LAMP BASE MOUNTING

Remove the remote lamp housing from the

remote lamp base by removing the knurled

nuts. Then install the remote lamp base to the

surface with the included mounting screws.

Using the remote lamp base as a template,

drill a 1" hole for the lamp.

Fig. 2 Lamp is secured with a sliding bracket tightened with two

knurled nuts.

(Fig.1)

(Fig.2)

INSTALLING THE LAMP

To maximize the efficiency and life of the UVC

lamp, clean each lamp prior to installation.

Use isopropyl alcohol and cotton cloth to wipe

dust and fingerprints from the lamp.

Gently insert the lamp into the lamp hole.

Slide the bracket over the retaining lip of the

lamp and tighten the two knurled nuts until the

lamp is securely fastened. The lamp seals

against the base of the unit using a rubber

grommet which prevents air leaks. Repeat for

each lamp of the installation.

Fig. 3 Lamp is secured with a sliding bracket tightened with two

knurled nuts.

NOTICE

Clean lamp(s) prior to installation.

Failure to remove dirt and fingerprints from

the lamp(s) could shorten their lifespan.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or perma-

nent loss of vision, and sunburn. To prevent

exposure, do not install device in any appli-

cations that allows UV-C light to be visible

after installation.

CAUTION

Sharp Edge Hazard.

Be careful of sharp edges on device and

HVAC equipment while installing the device.

Personal injury may result.

(Fig.3 )