Dustbane 19677 Betriebshandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Gebläse Dustbane 19677 herunter. Dustbane 19677 16 Seiten. Gladiator series

Seite drucken

19. Control Panel Display codes

Safety code

C22

C14

FS0

SP1

Yellow led lit

Red led flashes

P1.X

P2.X

SF.X

X = A VALUE FROM "0" TO "9"

20. Programming

Your machine is factory programmed for optimum performance. It does not require further programming.

However, if you encounter one of the following codes; P1.x, P2.x or SF.x (x= a value from 0 to 9), use the

following programming instructions to reset your display. Operating the machine in a setting other than the

factory setting may cause machine failure. Machine damage due to improper programming will void your

warranty.

PROGRAMMING INSTRUCTIONS:

If your display reads P1.0 , P2.1 or SF.3 simply turn the main power off and back on again to reset display (these

are the factory programmed settings). If your display reads a value greater than stated above (ex. P1. " 5" , P2. " 7" ,

SF. " 9") continue to follow the instructions as described below

To reprogram the machine to the factory settings, turn the main power ON and press and hold the display

switch button (battery/time symbols) down for at least 3 seconds. P1.x will appear on the display. The P1 value

should read "0" (ex. P1.0). If the value is greater than "0", press the vacuum fan button until the display reads P1.0.

Press the display switch button again to advance to the next code. The P2.x value should read "1" (ex. P2.1). Press

the vacuum fan button to properly set. Press the display switch one more time to advance to the last code. This

code should read SF.3. If the value is not "3", press the filter shaker button until the display reads SF.3. To exist the

programming mode, turn machine off.

Cause

Short circuit brush protection:

stops all functions

Dissipater at high temperature. Activates if

temperature is over 194° F

Worn brushes

BRUSHES KO

Battery in reserve

Sweeping mode 1 button programming

activated

Sweeping mode 1 button

programming activated

Sweeping mode 2 button

programming activated

Filter shaker program setting activated

Actions to take

Reset by turning OFF the machine and

starting again

The machine resets when temperature lowers

under 176° F

Replace brush

Error can only be reset by turning off the

machine. This alarm condition arises if the

brushes are put in SHUTDOWN condition

three times in a minute.

Machine continues to work. Only a warning

that the battery is near discharge.

Machine stops all functions. Turn off machine

and charge the battery.

See programming