CB Tech WaterBox Betriebshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Water Filtration Systems CB Tech WaterBox herunter. CB Tech WaterBox 20 Seiten. Mobile water filtration system

Seite drucken

SYSTEM DOES NOT RUN:

1. CHECK POSITION OF POWER SWITCH ON ELECTRICAL CONTROL PANEL

2. VERIFY POWER SOURCE VOLTAGE MATCHES SWITCH SETTING

3. FOR AC POWER (120 VAC/230 VAC) CYCLE THE GFI SWITCH (PRESS "TEST" BUTTON

THEN "RESET" BUTTON)

4. DISCONNECT POWER AND CHECK ALL WIRING CONNECTIONS (INCLUDING THAT

BETWEEN POWER SUPPLY CONTROL BOX AND PUMP)

5. IF PUMP IS HOT FROM PREVIOUS USAGE, ALLOW TO COOL (PUMP'S THERMAL

PROTECTION SWITCH WILL DISABLE POWER TO PREVENT DAMAGE)

SYSTEM DOES NOT PRIME (NO SUCTION):

1. CHECK HEIGHT OF PUMP ABOVE WATER SOURCE. IF HEIGHT IS MORE THAN 14'

(4.3M) PUMP MUST BE MANUALLY PRIMED

2. CONFIRM INLET HOSE, OUTLET HOSE AND BOTH WATER INTAKES ARE FREE FROM

OBSTRUCTION

3. CHECK ALL HOSE CONNECTIONS BETWEEN PUMP AND WATER SOURCE FOR LEAKS

(APPLY PETROL-GEL TO O-RINGS IF NECESSARY)

4. CONFIRM PUMP INLET STRAINER IS CLEAR OF DEBRIS (SEE Figure 6)

5. WITH THE PUMP TURNED ON, PRESS AND HOLD THE AIR PRESSURE RELIEF VALVE

ON THE FIRST STAGE I FILTER HOUSING UNTIL THE PUMP IS PRIMED (SEE Figure 7)

SYSTEM PRODUCES WEAK FLOW (< 0.50 GPM):

1. VERIFY (VIA PRESSURE DROP) THAT THE FILTERS HAVE NOT REACHED THEIR

USEFUL LIFE

2. CHECK ALL PLUMBING CONNECTIONS FOR LEAKS (APPLY PETROL-GEL TO O-RINGS

IF NECESSARY)

3. CONFIRM INLET HOSE, OUTLET HOSE AND WATER INTAKE ARE FREE FROM

OBSTRUCTION

4. CONFIRM THE STAGE I AND STAGE II FILTER HOUSINGS HAVE BEEN PURGED OF

TRAPPED AIR

5. CONFIRM PUMP INLET STRAINER IS CLEAR OF DEBRIS (SEE Figure 6)

6. USE CAUTION TO VERIFY PUMP IS NOT OVERHEATING, IF SO ALLOW PUMP TO

COOL

TROUBLESHOOTING

Page 3 of 20