CB2 Swig Montageanleitung - Seite 3
Blättern Sie online oder laden Sie pdf Montageanleitung für Inneneinrichtung CB2 Swig herunter. CB2 Swig 7 Seiten. Mini bar
swig
MINI BAR
left side
panel
NOTE: Make sure grooves
of left side panel and
partition are assembled
on the same side
Fit dowels of left side panel and partition into
corresponding holes of left fixed shelf as shown.
Using a screwdriver, turn each cam clockwise until
5
it securely engages each cam screw.
flat washer
bolt
bottom
panel
Fit dowels of partition and left/right side panels
into corresponding holes of bottom panel as
shown. Secure bottom panel with 6 bolts, 6
spring washers and 6 flat washers as shown,
7
using an phillips head screwdriver.
Made in Vietnam - r03
NOTE: Make sure cams
are positioned towards
the bottom of assembly
as shown
left fixed
shelf
partition
NOTE: Do not over
tighten the bolts
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
NOTE: Make sure plastic
piece on crossbar faces up
and bends towards the back
of assembly as shown
A
A) Fit dowels of assembly into corresponding holes
of right fixed shelf as shown. Secure cams.
B) Fit dowels of crossbar into corresponding holes
of assembly as shown. Secure cams.
C) Fit dowels of right side panel into
corresponding holes of right fixed shelf. Secure
cams.
D) Fit dowels of crossbar into corresponding
6
holes of right side panel. Secure cams.
With the assistance of another adult, carefully
position unit upright. Slide back panel into
8
grooves of assembled unit as shown.
B
crossbar
D
C
right fixed
shelf
right side
panel
back
panel
Page 3 of 7