Datalogic Memor 11 Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für PDA Datalogic Memor 11 herunter. Datalogic Memor 11 3 Seiten. Rugged mobile computer with 1d/2d imager

Datalogic Memor 11 Handbuch
WARNING: The area in which the units are charged should be clear of debris and
combustible materials or chemicals.
Do not use the battery pack of this terminal to power devices other than this device.
Avoid storing batteries for long periods in a state of continuous charging, full charge
or very low charge, especially at temperature higher than 30°C.
Periodically check the battery status and immediately discontinue use of the battery
pack if, while using, charging or storing the battery pack, the battery pack emits an
unusual smell, feels hot, changes colour or shape, swelling or appears abnormal in
any other way.
Do not short-circuit the battery pack contacts connecting the positive terminal and
negative terminal. This might happen, for example, when you carry a spare battery
pack in your pocket or purse; accidental short-circuiting can occur when a metallic
object such as a coin, clip, or pen causes direct connection of the contacts of the
battery pack (these look like metal strips on the battery pack). Short-circuiting the
terminals may damage the battery pack or the connecting object.
Do not apply voltages to the battery pack contacts.
Do not pierce the battery pack with nails, strike it with a hammer, step on it or
otherwise subject it to strong impacts, pressures, or shocks.
Do not disassemble or modify (i.e. bend, crush or deform) the battery pack. The
battery pack contains safety and protection devices, which, if damaged, may cause
the battery pack to generate heat, explode or ignite.
In case of leakage of liquid from the battery, avoid contact with liquid the skin or
eyes. If the contact occurs, immediately wash the affected area with water and
consult a doctor.
Do not solder directly onto the battery pack.
Do not expose the battery pack to liquids.
Avoid any knocks or excessive vibrations. If the device or the battery is dropped,
especially on a hard surface, you should take it to the nearest Authorised Repair
Centre for inspection before continuing to use it.
If your device stops working for any reason, do not use its battery on other electronic
devices without a prior check and approval by an Authorised Repair Centre.
Do not remove or damage the battery pack's label.
Do not use the battery pack if it is damaged in any part.
Battery pack usage by children should be supervised.
Collect and recycle waste batteries separately from the device in compliance with
European Directive 2013/56, 2011/65, 2012/79 and subsequent modifications, with
US and China regulatory laws and regulations about the environment.
WIRELESS AND RADIO FREQUENCIES WARNINGS
WARNING: Most modern electronic equipment is shielded from RF signals. However,
certain electronic equipment may not be shielded against the RF signals generated
by MEMOR 11.
Datalogic recommends persons with pacemakers or other medical devices to follow
the same recommendations provided by Health Industry Manufacturers Associations
for mobile computers.
Persons with pacemakers:
• Should ALWAYS keep this device more than twenty five (25) cm from their
pacemaker and/or any other medical device;
• Should not carry this device in a breast pocket;
• Should keep the device at the opposite side of the pacemaker and/or any other
medical device;
• Should turn this device OFF or move it immediately AWAY if there is any reason
to suspect that interference is taking place.
• Should ALWAYS read pacemaker or any other medical device guides or should
consult the manufacturer of the medical device to determine if it is adequately
shielded from external RF energy.
In case of doubt concerning the use of wireless devices with an implanted medical
device, contact your doctor.
Turn this device OFF in health care facilities when any regulations posted in these
areas instruct you to do so. Hospitals or health care facilities may use equipment
that could be sensitive to external RF energy.
RF signals may affect improperly installed or inadequately shielded electronic
systems in motor vehicles. Check with the manufacturer or its representative
regarding your vehicle. You should also consult the manufacturer of any equipment
that has been added to your vehicle.
WARNING: An air bag inflates with great force. DO NOT place objects, including
either installed or portable wireless equipment, in the area over the air bag or in the
air bag deployment area. If a vehicle's wireless equipment is improperly installed
and the air bag inflates, serious injury could result.Turn off the device when in any
area with a potentially explosive atmosphere. Observe restrictions and follow closely
any laws, regulations, warnings and best practices on the use of radio equipment
near fuel storage areas or fuel distribution areas, chemical plants or where any
operation involves use of explosive materials.
Do not store or carry flammable liquids, explosive gases or materials with the device
or its parts or accessories.
Areas with a potentially explosive atmosphere are often, but not always, clearly
marked or shown.
Sparks in such areas could cause an explosion or fire, resulting in injury or even
death.
LED CLASS
LED illuminator integrated in the imager engine is classified as RISK GROUP 1 according to
IEC62471.
LASER SAFETY
The following information applies to Laser Aiming System, used on MEMOR 11. The laser light is
visible to the human eye and is emitted from the window indicated in the figure below.
LASER RADIATION - DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX OUTPUT RADIATION 1 mW
COMPLIANT WITH EN 60825-1 (2014)
NOTE: The artwork below may be only a draft. Please refer to the label attached to
the product for information about certification marks.
Laser Aperture/Ouverture Laser
ITALIANO
DEUTSCH
FRANÇAIS
LA LUCE LASER È VISI-
DIE LASER-STRAHLUNG
LE RAYON LASER EST
BILE ALL'OCCHIO UMANO
IST FÜR DAS MEN-
VISIBLE À L'OEIL NU
E VIENE EMESSA DALLA
SCHLICHE AUGE
ET IL EST ÉMIS PAR LA
FINESTRA INDICATA
SICHTBAR UND WIRD AM
FENÊTRE DÉSIGNÉE SUR
NELLA FIGURA.
STRAHLAUS TRITTSFEN-
L'ILLUSTRATION DANS
STER AUSGESENDET
LA FIGURE.
(SIEHE BILD).
LUCE LASER NON FIS-
LASERSTRAHLUNG
RAYON LASER EVITER DE
SARE IL FASCIO
NICHT IN DEN STRAHL
REGARDER LE RAYON
APPARECCHIO LASER
BLICKEN PRODUKT
APPAREIL LASER DE
DI CLASSE 2 MASSIMA
DER LASERKLASSE 2
CLASSE 2 PUISSANCE DE
POTENZA D'USCITA: 1
MAXIMALE AUSGANG-
SORTIE: 1 mW
mW
SLEISTUNG: 1 mW
LONGUEUR D'ONDE
LUNGHEZZA D'ONDA
WELLENLÄGE: 630~680
EMISE: 630~680 nm
EMESSA: 630~680 nm
nm
CONFORME A EN
CONFORME A EN
ENTSPR. EN 60825-1
60825-1 (2014).
60825-1 (2014).
(2014).
RF Exposure Information and Statement:
This device was tested for hand-held and body-worn conditions, according to international Stan-
dards covering human exposure to electromagnetic fields from radio devices. The SAR limit of EU
(CE) is 2.0 W/kg for trunk/head as averaged over any 10g tissue according to the EN 50360:2017
and EN 50566:2017. MEMOR 11 has also been tested against this SAR limit. The highest SAR
value reported under this standard during product certification for use at the ear is 0.49 W/kg
and when properly worn on the body is 0.79 W/kg. This device was tested for typical body-worn
operations. A minimum separation distance must be maintained between the user's body and the
handset, including the antenna:5mm to comply with the RF exposure requirements in Europe.
Third-party belt-clips, holsters and similar accessories used by this device should not contain
any metallic components. Body-worn accessories that do not meet these requirements may not
comply with RF exposure requirements and should be avoided.
MARKING AND EUROPEAN ECONOMIC AREA (EEA)
In radio systems configured with mobile computers and access points, the frequencies to be used
must be allowed by the spectrum authorities of the specific country in which the installation takes
place. Be absolutely sure that the system frequencies are correctly set to be compliant with the
spectrum requirements of the country.
The Radio modules used in this product automatically adapt to the frequencies set by the system
and do not require any parameter settings.
European Declaration of Conformity
Laser Warning Label
Hereby, Datalogic S.r.l. declares that this radio equipment is in compliance with Directive 2014/53/
EU. The full text of the EU declaration of conformity is available at: www.datalogic.com. Select
the Support & Service > Downloads > Product Certifications link where you can search for your
specific product certification.
Česky [Czech]
Tímto Datalogic S.r.l. prohlašuje, že toto rádiové zařízení je ve shodě se směrnicí 2014/53/EU.
Dansk [Danish]
Herved erklæres Datalogic S.r.l. erklærer, at dette radioudstyr er i overensstemmelse med
direktiv 2014/53/EU.
Deutsch [German]
Hiermit wird Datalogic S.r.l. erklärt, dass dieses Funkgerät der Richtlinie 2014/53/EU entspricht.
ESPAÑOL
Eesti [Estonian]
A LUZ LÁSER ES VISIBLE
Käesolevaga on Datalogic S.r.l. kinnitab, et see raadioseade on kooskõlas direktiiviga 2014/53/
AL OJO HUMANO Y ES
EL.
EMITIDA POR LA VEN-
TANA INDICADA EN LA
Español [Spanish]
FIGURA.
Por la presente, Datalogic S.r.l. declara que este equipo de radio cumple con la Directiva 2014/53/
UE.
RAYO LÁSER NO MIRAR
Ελληνική [Greek]
FIJO EL RAYO APARATO
LÁSER DE CLASE 2
Με το παρόν, Datalogic S.r.l. δηλώνει ότι αυτός ο ραδιοεξοπλισμός συμμορφώνεται με την Οδηγία
MÁXIMA POTENCIA DE
2014/53/ΕΕ.
SALIDA: 1 mW
LONGITUD DE ONDA
Français [French]
EMITIDA:
Par la présente, Datalogic S.r.l. déclare que cet équipement radio est conforme à la directive
630~680 nm
CONFORME A EN
2014/53/UE.
60825-1 (2014).
Italiano [Italian]
Con la presente Datalogic S.r.l. dichiara che questa apparecchiatura radio è conforme alla Direttiva
2014/53/UE.
Latviski [Latvian]
Ar šo Datalogic S.r.l. paziņo, ka šī radioiekārta atbilst Direktīvai 2014/53 / ES.
Use careful with the earphone maybe possible excessive sound pressure from
earphones and headphones can cause hearing loss.
CAUTION: The device shall only be connected to a USB interface of version USB
TYPE-C.
Adapter shall be installed near the equipment and shall be easily accessible.
The device should operating at temperature between -20-50 °C.